Chimney chase cover replacement for homes in Health District
A made-to-measure cover, fastened into sound framing and backed by our workmanship warranty.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
What a worn chase cover looks like in Health District
- Holes rusted through the cover
- Loose screws along the skirt
- Gap around the pipe collar
- Chimney pipe leaning in its collar
Jump to
Chase cover replacement explained for Health District
Covers with a screened, lidded section
Some cover makers offer a design with a screened section and a removable lid built around the pipe opening. It can help keep birds and debris off the top of the pipe. One chimney maker's instructions also allow extra screening on field-made chase covers.
Anything that works as a shroud still has to follow the listing rules for the chimney. We check what the chimney maker allows before proposing a screened design. If it suits your chimney, the estimate describes it. If it does not, we explain why a plain cover and the listed cap are the better route.
Galvanized covers and how they age
Galvanized steel is a common chase cover material. Its zinc coating protects the steel for a time, and how long depends on weather, rainfall and what the air carries. Once the zinc wears through, corrosion takes hold, especially where water sits.
A galvanized cover can be a fair choice on a chase that sheds water well, and it can be painted. It is not a buy-once item. We check the coating on your current cover for bare patches and holes. Then we explain what to expect from a new galvanized cover, without putting a number of years on it.
Water timing that points to the source
Notice when water appears. Water inside during a heavy downpour often points to a hole in the cover or a failed storm collar, where the path is short. Water that shows up a day later, or only when wind blows from one side, may be soaking through siding or around trim instead.
Keep a simple note of the date, the weather and where the water appeared. Share it when you arrange the free inspection. That record helps us check the most likely source first and avoids replacing a cover that was not the problem.
Birds and debris on the chase top
Chase tops can collect twigs, leaves and nesting material, especially around the pipe and under a cap. Debris holds moisture against the metal and can block the air spaces the chimney needs at the top.
We clear loose material from the chase top as part of the job and look for nesting inside the cap. If an animal is living in the chimney, removal comes first as a separate service. Some cover makers offer screened designs, and one chimney maker allows extra screening on field-made covers, which we can discuss if birds are a repeat problem.
Measured before a chase cover is ordered
- Cross-breaks or slope to shed water
- Cover metal and gauge named
- Screened lid section where listed
- Written record of the cover work
What people ask about chase covers
Is the fireplace safe to use while the chase leaks?
Water in a chase can reach the chimney pipe and the fireplace below it. If you see water inside or fresh corrosion in the firebox, stop using the fireplace and have the chase top and chimney checked before the next fire.
Can you fit a cover with a screened, lidded section?
Some chase covers can be made with a screen and removable lid around the pipe. On a factory-built chimney, anything that acts as a shroud has to be listed for that chimney, so we check the maker's options before quoting one.
What should I tell you when I call about the chase?
Describe what you see from the ground, any stains or water inside and whether the fireplace is used. Mention the chimney maker if you know it. With that, we can plan the visit to your home in Health District and bring the right gear.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo