Chimney chase cover replacement for homes in Lake Estates
Framing damage under the old cover is shown to you and priced on its own line.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Signs a chase cover in Lake Estates is failing
- Holes rusted through the cover
- Rust flakes inside the fireplace
- Gap around the pipe collar
- Cover shifted after a strong storm
Jump to
Building a chase cover that sheds water
Stainless covers and the grade question
Stainless steel covers resist corrosion better than bare steel, and cover makers commonly build them with welded seams. Stainless is not one material, though. Grades vary, and the screws, collar and storm collar may not match the sheet.
Ask which grade the cover uses and what the fasteners are made of. We put both on the estimate. The aim is a cover whose parts weather at a similar pace, so a sound sheet is not let down by a corroding screw or collar. That is part of why we name every part, not only the sheet.
Water timing that points to the source
Notice when water appears. Water inside during a heavy downpour often points to a hole in the cover or a failed storm collar, where the path is short. Water that shows up a day later, or only when wind blows from one side, may be soaking through siding or around trim instead.
Keep a simple note of the date, the weather and where the water appeared. Share it when you arrange the free inspection. That record helps us check the most likely source first and avoids replacing a cover that was not the problem.
Repair the cover or replace it
Not every chase cover needs replacing. A sound cover with a loose screw or cracked sealant at the collar can often be repaired for a fraction of the effort. A cover with holes, a sagging middle or corroded seams usually cannot.
We explain which situation you have and show you the evidence. If a repair will do the job, the estimate says so. Where replacement is the better answer, we explain why in a sentence. Either way, you see the options and their prices before choosing, and nothing is replaced simply because it is easier for us.
Reaching the chase top safely
Chase tops can be awkward to reach. The chase may rise from a steep section of roof, sit close to the edge or stand tall above the roof line. We look at the access before climbing and plan it so the roof covering is not damaged along the way.
If you know of fragile roof areas, recent repairs or loose sections near the chase, tell us. We note the roof condition around the chase in the findings. Where we see roof damage outside our work, we describe it plainly so you can pass it to a roofer.
Parts of the chase job priced separately
- Cross-breaks or slope to shed water
- Cover metal and gauge named
- Top of the framing checked once exposed
- Roof access planned around the chase
What people ask about chase covers
Do you make chase covers to measure?
Yes. Chases vary in size and pipe position, so most covers are made to the measurements we take on the roof. That can mean one visit to measure and another to fit, and we explain the sequence at the start.
Which metal should a replacement chase cover be made from?
Galvanized, stainless and copper covers are all made. The choice depends on the chimney, the metals nearby, the look you want and the budget. We name the metal and its gauge on the estimate and explain why we suggest it.
What should I tell you when I call about the chase?
Describe what you see from the ground, any stains or water inside and whether the fireplace is used. Mention the chimney maker if you know it. With that, we can plan the visit to your home in Lake Estates and bring the right gear.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo