Spalled and cracked chimney bricks replaced in Beverly Heights
You see which bricks need replacing and which only look marked before approving any work.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
When chimney brick faces start to break
- Corners broken off several bricks
- Crumbling brick near the ground
- Stains inside beside the chimney
- Damp patches that stay on damaged bricks
Jump to
Replacing chimney bricks the careful way
Cracks that run through the brick face
A hairline line on the surface of a brick is different from a crack that runs through its face. Brick industry guidance treats cracks extending through the face shell as a reason to replace the unit.
We look at the crack's width, its path and whether the face on either side sits level. A crack through the face can let water into the brick and the wall behind. That unit goes on the replacement list, and we look at what cracked it before choosing the new one.
Firebrick inside the firebox is not this job
The brick lining a masonry firebox faces direct fire. It is a different material, laid in refractory mortar, and repairing it is firebox repair, not exterior brick replacement.
If you notice cracked or crumbling firebrick, mention it. We look at it during the inspection and explain what it needs. Exterior brick replacement and firebox repair each have their own line on the estimate, and each uses the materials its location requires. Cracked firebrick can also affect how the fireplace should be used, so we explain that as part of the findings.
Rain and fresh mortar around new bricks
Fresh mortar around a new brick is soft at the surface. Heavy rain can wash fine material out of the joints and streak the brick below. New units are protected when rain is likely.
If rain threatens during the work, we cover the day's repairs before leaving and may move the schedule. A short delay is better than redoing the joints. Tell us if you see covers moved by wind so we can reset them. We also check the covered work before starting again the next day.
The order of repairs around damaged brick
When a chimney needs several repairs, the order matters. The water source, whether crown, cap or flashing, is usually fixed first. Loose top courses are dealt with before any new crown. Damaged bricks lower down are then replaced.
Working in that order means new brick goes into a chimney that is no longer being soaked. We explain the sequence on your estimate and show which items you have approved. If you delay one item, we explain how it affects the others.
Before you approve brick replacement in Beverly Heights
- Careful cutting of surrounding mortar
- Joints pointed full around new units
- Mortar suited to the existing joints
- Overnight cover for an open chimney top
Spalling brick repair questions from Beverly Heights
How many bricks can be replaced before a bigger repair is needed?
There is no fixed count. It depends on how the damage is spread and whether the masonry around it is sound and not moving. When damaged units cluster in large areas or courses are loose, we explain a partial rebuild instead.
Should I pull off loose pieces of brick myself?
No. Pulling on loose pieces can bring down more than you expect, and working on a roof carries real risk. Keep people clear of the area below and tell us what you have seen.
Does the workmanship warranty cover replaced bricks in Beverly Heights?
Yes, the agreed brick replacement carries our workmanship warranty. The written record lists which units were replaced and where, so any question later can be checked against the work that was done.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo