Chimney brick replacement done unit by unit in Coral Springs
You see which bricks need replacing and which only look marked before approving any work.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
When chimney brick faces start to break
- Cracks running through single bricks
- Bricks that look loose or pushed out
- Spalled brick just above the roofline
- Stains inside beside the chimney
Jump to
What careful brick replacement involves
Brick damaged by past harsh cleaning
Past sandblasting and past acid cleaning both appear in brick industry maintenance guidance among the possible causes of masonry distress. Either can damage the brick surface and leave it more open to water.
Federal preservation guidance adds that acids should never be applied to dry masonry. If you know the chimney was blasted or acid-washed in the past, tell us. It helps explain widespread surface damage and shapes how we clean around new units. We then choose the gentlest way to clean mortar from the new work.
Brick corners damaged by earlier grinding
Chipped brick edges along the joints can trace back to an earlier repointing done with a grinder. Federal preservation guidance shows how power tools used on thin joints break brick edges and overcut the joints.
Damaged edges make joints look wider and leave thin mortar at the face. Where the damage is cosmetic, the bricks may stay. Where edges have broken away enough to let water in, replacing the unit may be the better answer. We explain which applies to each area.
A free inspection before any brick comes out
Brick replacement starts with a free inspection. We check each face of the chimney, mark damaged units and test suspect bricks. The crown, cap, flashing and joints that could be sending water into the wall are checked too.
The findings are explained on site, and a free written estimate follows that sets out every item separately. There is no charge and no obligation. If the bricks can wait, we say so and explain what would make replacement necessary. Keep the written findings for any later visit.
White deposits beside flaking brick
White deposits near spalled brick are salts that water dissolved inside the wall and left at the surface as it dried. When they appear beside flaking faces, they show that water is moving through that part of the wall.
We treat them as a clue to the water path, not a separate problem. Finding where the water enters comes before replacing the damaged units. It may be the top, the flashing or open joints, and the new brick should not face the same wetting.
What we check before quoting brick work
- Survey of damaged units on each face
- Surface marks separated from face loss
- Color, texture and range compared
- Mortar suited to the existing joints
Questions to ask before replacing bricks
How does the inspection discount apply to brick replacement?
Say yes to the brick replacement within 72 hours after your free inspection and we take 10% off the services you book. Those hours run from your own inspection visit.
What should I tell you when I call about damaged brick?
Mention which side of the chimney shows damage, whether pieces have fallen and whether water shows inside. Tell us about past repairs, coatings, paint or sealers. That history helps explain why the brick failed.
Is spalled brick near the ground treated differently?
Brick near the ground can stay wet from the soil or from water splashing back. Brick industry guidance lists rising damp among possible causes of masonry distress. We look at drainage and plantings at the base as well as the brick itself.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo