Spalled brick replacement on chimneys in Home Beautiful Park
Damaged units come out, sound brick stays, and the new brick is matched in size, color and texture.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
When chimney brick faces start to break
- Brick faces flaking or popping off
- Cracks running through single bricks
- Brick cores showing where faces fell
- Mortar gone around a loose brick
Jump to
Replacing chimney bricks the careful way
Mapping which chimney bricks need replacing
Before any brick comes out, we map the damage. Each face of the chimney is checked and the units that need replacing are noted by position. The map also shows where damage clusters, which can point to the water source.
You receive that map as part of the estimate, in plain words. It lets you see how many units are involved and where they are. If the pattern suggests a wider problem, such as damage running along a line of movement, we explain that before proposing single-brick repairs.
Keeping people clear of falling fragments
Spalled brick sheds pieces, and pieces falling from a chimney can hurt someone. If you see fragments landing on a path, a patio or the drive, keep people and pets away from that area until the chimney has been looked at.
Tell us where the pieces are landing when you call. It helps us judge how active the damage is and plan the visit. During the work, we protect the area below the chimney and explain where it is safe to walk.
Holding off on cleaners after the work
New mortar needs time to harden before any cleaner touches it. Federal preservation guidance warns against applying acids to dry masonry and notes that new joints are especially vulnerable to damage from cleaning.
If you plan to clean the chimney, wait until we confirm the joints have hardened, and start with plain water and a soft brush. You get a short list of products to avoid while the joints mature, so a well-matched repair is not stained or etched. Ask us before using any product you are unsure about.
Damp or stains inside near damaged brick
Water that gets through a spalled brick can travel into the wall and show up inside. You may see a stain on a ceiling beside the chimney, damp plaster near the fireplace or dampness in the attic next to the masonry.
Tell us what you have seen inside when you book. We look at the exterior brick with that in mind and check the other parts that could be involved. That helps us explain whether replacing units is likely to stop the water or whether another repair is also needed.
What we check before quoting brick work
- Survey of damaged units on each face
- Careful cutting of surrounding mortar
- Mortar suited to the existing joints
- Written record of units replaced
Spalled brick replacement answers
Why do the faces of chimney bricks come away?
Usually because water gets into the brick and something stops it drying out through the joints. Soluble salts can crystallize under the face, and hard mortar or a film coating can make it worse. We look for the source before replacing units.
What should I tell you when I call about damaged brick?
Mention which side of the chimney shows damage, whether pieces have fallen and whether water shows inside. Tell us about past repairs, coatings, paint or sealers. That history helps explain why the brick failed.
Can one cracked brick wait, or should it be replaced now?
A single hairline crack in an otherwise firm brick may be watched. A crack through the face, a loose unit or a face that is coming away should be replaced, because water can keep entering there. We explain which applies.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo