
Spalled brick replacement on chimneys in Homestead
Chimney brick replacement in Homestead is priced upfront, with no hidden fees and a written record.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Clues that point to spalled brick
- Corners broken off several bricks
- Bricks that look loose or pushed out
- Chipped edges where joints were ground out
- Mortar gone around a loose brick
Jump to
Brick replacement that deals with the cause
Loose top courses under a failing crown
Loose bricks at the very top of a chimney are often a sign that the crown and the courses under it have taken water for a long time. The mortar there may have washed out, and several units may lift together.
Replacing a few bricks may not be enough in that case. We explain whether the top courses need relaying before a new crown can sit on them. That work is priced separately, and the brick replacement lower down is planned around it.
Cracked bricks along a stepped crack line
When cracks run through several bricks in a stepped or diagonal line, the chimney may have moved. Brick industry guidance lists that pattern among the signs of a structural issue, and replacing the units without knowing why they cracked can hide ongoing movement.
We look at the direction of the crack line and whether the bricks on either side have shifted, then explain what further assessment the cause needs. Cracked units are replaced once that cause is understood, not before.
A record of which bricks were replaced
After the work, you receive a written record listing the units replaced and where they sit on the chimney. It also notes the brick and mortar used and anything we saw that falls outside the job.
That record is useful later. If more bricks need replacing, the same brick and mortar can be sourced again. If you sell the house, it shows what was done. Keep it with your other papers about the home. It also helps a future contractor understand what is already in the wall.
Broken brick at the chimney corners
The corners of a chimney take weather on two sides, and corner bricks can show damage first. Broken corners also let water into the joints on both faces they touch.
Corner units are replaced with care, because they tie two faces together. The replacement brick has to fit the corner detail, and the joints on both sides are pointed full. We explain whether corner damage is local or part of a wider pattern that needs another look. A corner that is replaced well also protects the joints on both sides from water.
Separate lines for bricks, joints and water
- Separate line for wider repointing
- Separate lines for crown or flashing work
- Debris removal and haul-away
- Written record of units replaced
Brick replacement answers for Homestead
Can a crumbling brick just be patched with mortar?
A skim of mortar over a lost face is not a brick. It tends to crack away and can hold water against the damaged unit. We cut out and replace units that have lost their face or cracked through.
Why are bricks from an earlier replacement flaking again?
When replacement units fail in the same spot, the cause may not have been fixed. Water may still reach that area, the mortar may be too hard or the brick may not suit the exposure. We look for the cause before replacing them again.
Should I pull off loose pieces of brick myself?
No. Pulling on loose pieces can bring down more than you expect, and working on a roof carries real risk. Keep people clear of the area below and tell us what you have seen.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting Copperfield Chimney Supply 
Rutland Heatilator Heat & Glo

