Spalling brick repair for chimney faces in Lauderdale Isles
If the damage is too widespread for single bricks, we explain the wider repair it needs.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Clues that point to spalled brick
- Brick fragments on the roof or ground
- Spalled brick just above the roofline
- Bright hard joints beside broken faces
- Chipped edges where joints were ground out
Jump to
What careful brick replacement involves
Coatings that trap moisture behind the face
Some coatings form a film on the brick. Brick industry guidance on clear coatings explains that film formers slow the drying of the masonry through its face. Water held inside can lead to clouding and to spalling.
If your chimney was sealed or painted and the faces are now coming away, the coating may be involved. We explain what we see and whether the remaining coating affects the replacement work. New units are not coated as part of the job, and any later treatment is discussed separately.
When more damaged bricks turn up
Once a damaged unit is out, the brick beside it is easier to judge. Sometimes a neighboring unit that looked sound turns out to be cracked or loose, and the count changes.
When that happens, we stop and show you. The extra unit is explained and priced before it is added. You decide whether it is replaced now or noted for later. The agreed scope does not grow quietly while you are not looking. You also see the extra unit before it comes out, so the decision is based on what is actually there.
New brick beside weathered brick
A replacement brick has not seen weather yet. Even a close match in color and texture can look slightly cleaner or sharper than the bricks around it on the day it goes in.
We tell you what to expect before approval and choose units that sit within the range of the existing wall. The difference is usually most noticeable up close and in strong light. From the ground, a well-chosen brick in well-matched joints tends to disappear into the chimney.
When damaged brick can wait
Not every inspection ends with bricks being replaced. A chimney can show light surface wear, a stable hairline crack or shallow flaking that is not letting water in. In that case, replacement may not be needed yet.
We tell you what we checked and what would change the answer, such as a face coming away, a crack opening or pieces falling. A maintenance visit later can confirm how the brick is holding. Work the chimney does not need does not go on your estimate.
What your brick replacement estimate lists
- Water source notes before replacement
- Break-out of each damaged unit
- Opening cleaned of dust and fragments
- Surfaces dampened before setting
Brick replacement answers for Lauderdale Isles
Why do the faces of chimney bricks come away?
Usually because water gets into the brick and something stops it drying out through the joints. Soluble salts can crystallize under the face, and hard mortar or a film coating can make it worse. We look for the source before replacing units.
Can you replace bricks on the part of the chimney above the roof?
Yes. Access is planned from the roof, with protection for the roof covering. Bricks near the top often take the most water, so we also check the crown and cap above them before replacing units.
Does the fireplace need to stay unused during brick replacement?
Sometimes, while mortar around the new units cures and while any opening near the flue is closed up. Where the new bricks sit decides how long, and we give you a clear point to resume fires.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo