Spalled brick replacement on chimneys in Navarro Isle
A coating cannot restore a brick face, so spalled units are replaced before anything else is considered.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Brick trouble you can spot from the yard
- Brick fragments on the roof or ground
- Brick cores showing where faces fell
- Earlier replacement bricks failing again
- Damage worst near the chimney top
Jump to
Brick replacement that deals with the cause
Breaking out a damaged brick
A damaged unit comes out in pieces, not whole. Brick industry maintenance guidance describes breaking it to help removal, which puts less strain on the surrounding bricks than trying to pry it free.
We break the damaged unit carefully and lift out the pieces. The bricks above, below and beside the opening stay supported by their own mortar throughout. If a neighboring brick turns out to be loose once the damaged one is out, we stop and show you before going further.
A clear sealer applied before the spalling
Sometimes a chimney was sealed to stop a leak, and the faces began to flake afterwards. Brick industry guidance explains that some coatings slow drying through the brick face, and water held inside can push the surface off.
Tell us if you know a sealer was applied and roughly when. We check how it is behaving on the remaining brick. The damaged units are replaced, and we explain whether the sealer is still a risk to the bricks around them.
Covering an open top during brick work
Most brick replacement leaves the top of the chimney closed. When work near the top means lifting the cap or leaving the flue open, rain and debris could get in.
If the chimney is open when we stop for the day, the opening is covered until we return. The cap goes back once the upper work is done. Worn fixings or a damaged cap are pointed out and priced as their own item. Covering the opening is routine for us, not an extra charge.
Holding off on cleaners after the work
New mortar needs time to harden before any cleaner touches it. Federal preservation guidance warns against applying acids to dry masonry and notes that new joints are especially vulnerable to damage from cleaning.
If you plan to clean the chimney, wait until we confirm the joints have hardened, and start with plain water and a soft brush. You get a short list of products to avoid while the joints mature, so a well-matched repair is not stained or etched. Ask us before using any product you are unsure about.
Your spalling brick repair scope in writing
- Water source notes before replacement
- Replacement brick matched in size
- Written record of units replaced
- Upfront price for each replacement area
Brick replacement answers for Navarro Isle
Can you replace only the damaged bricks on my chimney?
Yes, where the masonry around them is sound. We cut out the spalled or cracked units, clean the openings and set matching brick in mortar that suits the wall. If damage is widespread or the chimney is moving, we explain a wider repair instead.
Can you replace bricks on the part of the chimney above the roof?
Yes. Access is planned from the roof, with protection for the roof covering. Bricks near the top often take the most water, so we also check the crown and cap above them before replacing units.
How does the inspection discount apply to brick replacement?
Say yes to the brick replacement within 72 hours after your free inspection and we take 10% off the services you book. Those hours run from your own inspection visit.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo