Spalled brick replacement on chimneys in Olympia Heights
You see which bricks need replacing and which only look marked before approving any work.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
When chimney brick faces start to break
- Bricks that look loose or pushed out
- White deposits around damaged bricks
- Damage worst near the chimney top
- A clear sealer flaking off the brick
Jump to
Spalled brick replacement, explained plainly
Joints around new bricks and wider repointing
The joints immediately around each replaced brick are part of the replacement. Joints elsewhere on the chimney that have eroded or cracked are a separate question, answered by repointing.
We keep that boundary clear on the estimate. If the joints near the damaged bricks are failing too, we explain whether repointing that area makes sense at the same visit. It appears as its own item, so you can see what the brick replacement covers and what the joint work adds.
A free inspection before any brick comes out
Brick replacement starts with a free inspection. We check each face of the chimney, mark damaged units and test suspect bricks. The crown, cap, flashing and joints that could be sending water into the wall are checked too.
The findings are explained on site, and a free written estimate follows that sets out every item separately. There is no charge and no obligation. If the bricks can wait, we say so and explain what would make replacement necessary. Keep the written findings for any later visit.
Curing care for new brick joints
Federal preservation guidance explains that mortar left to dry too quickly bonds poorly and weathers early. It recommends keeping new work damp and shaded from strong sun while it cures.
We plan that care into the job. It may mean misting the new joints or leaving covers in place. We tell you what to leave alone, such as covers or the area around the repair, and what to avoid, such as washing the chimney while the joints harden. That care is part of the price, not an add-on.
Vines on a chimney and the brick beneath
Vines growing up a chimney can hold moisture against the brick and push into weak joints. The brick industry's maintenance note says to cut vines away from the wall, since pulling them off can damage the brickwork.
If vines cover damaged areas, they are cut back and the remaining growth is left to dry before it is brushed off. We can then see the brick underneath properly. Replacement units are set once the surface is clear, and we explain whether the growth has affected the joints.
What we check before quoting brick work
- Soft-bristle cleanup of mortar smears
- Debris removal and haul-away
- Workmanship warranty on agreed brick work
- Aftercare notes and repellent timing
Spalling brick repair questions from Olympia Heights
Will new bricks stop water getting into the house?
They can close an entry point where broken brick lets water in. Water can also enter through the crown, flashing or joints. We explain what the brick work addresses, and a hose water test comes into it only if the job calls for one.
How does the inspection discount apply to brick replacement?
Say yes to the brick replacement within 72 hours after your free inspection and we take 10% off the services you book. Those hours run from your own inspection visit.
Is spalled brick near the ground treated differently?
Brick near the ground can stay wet from the soil or from water splashing back. Brick industry guidance lists rising damp among possible causes of masonry distress. We look at drainage and plantings at the base as well as the brick itself.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo