Spalled brick replacement on chimneys in Tamarac
Replacing spalled brick in Tamarac, set in full joints and tooled to shed water.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Spalling brick signs to mention when you call
- Damage worst near the chimney top
- Spalled brick just above the roofline
- Chipped edges where joints were ground out
- Vines rooted over damaged brick
Jump to
How we approach spalling brick repair in Tamarac
Mapping which chimney bricks need replacing
Before any brick comes out, we map the damage. Each face of the chimney is checked and the units that need replacing are noted by position. The map also shows where damage clusters, which can point to the water source.
You receive that map as part of the estimate, in plain words. It lets you see how many units are involved and where they are. If the pattern suggests a wider problem, such as damage running along a line of movement, we explain that before proposing single-brick repairs.
Dampening before the new brick goes in
Dry brick pulls water out of fresh mortar too fast. Brick industry guidance asks for the surrounding brick to be dampened before a new unit is set. Surface water should soak in first, so the bond is good.
We wet the opening and the new brick as the material requires, then wait for the surface film to disappear. On a warm, dry day that step matters more. It is one of several small steps that decide whether the new unit stays tight or loosens later.
When light surface flaking can wait
Some brick shows light surface flaking that has not gone deep and is not spreading quickly. If the unit is firm, the flaking is shallow and water is not getting through, replacing it straight away may not be necessary.
We tell you when that is the case and what to watch for. Deeper loss, a crack through the face or a unit working loose would change the answer. A maintenance visit later can show whether the flaking has progressed, so any replacement happens when it is actually needed.
The order of repairs around damaged brick
When a chimney needs several repairs, the order matters. The water source, whether crown, cap or flashing, is usually fixed first. Loose top courses are dealt with before any new crown. Damaged bricks lower down are then replaced.
Working in that order means new brick goes into a chimney that is no longer being soaked. We explain the sequence on your estimate and show which items you have approved. If you delay one item, we explain how it affects the others.
Brick replacement priced area by area
- Surfaces dampened before setting
- Tooling to match the existing profile
- Protection for roof, windows and plantings
- Curing care for the new joints
Spalling brick repair questions from Tamarac
How do you match new brick to an older chimney?
We compare size, color, texture and the range of shades in the wall, and we can set out a sample to judge the match. Finding a close brick can take some searching. New brick may look fresher at first.
Should I pull off loose pieces of brick myself?
No. Pulling on loose pieces can bring down more than you expect, and working on a roof carries real risk. Keep people clear of the area below and tell us what you have seen.
Will you check the crown while replacing bricks near the top?
Yes. Bricks near the top often suffer because water comes from above. We check the crown, cap and flue seal, and if one of them is failing, we explain it and price it separately.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo