Spalled and cracked chimney bricks replaced in Tamiami
Spalling brick repair in Tamiami begins by marking each damaged unit during a free inspection.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
When chimney brick faces start to break
- Stains inside beside the chimney
- Damp patches that stay on damaged bricks
- Bright hard joints beside broken faces
- A clear sealer flaking off the brick
Jump to
How we approach spalling brick repair in Tamiami
Keeping brick debris out of the flue
Behind the outer brick of a chimney lies the flue. Brick industry guidance warns against letting debris fall into the hidden air space of a brick wall, where it can block drainage. In a chimney, the hidden space behind the brick is the passage smoke and gases use.
We work so fragments fall outward into collection, not inward toward the flue. If any material does drop inside, we tell you and clear it. A replacement that leaves broken brick sitting on a smoke shelf or damper would trade one problem for another.
When the count of damaged bricks grows large
Single-brick replacement suits damage scattered through otherwise sound masonry. When damaged units cluster across large areas, or whole courses are loose, cutting out bricks one by one stops making sense.
We explain where that line falls on your chimney. A partial rebuild of the affected section may be the sounder repair, and it is priced as its own job. You see both options with their reasons, so the choice between them is yours and made with the full picture. Sound sections of the chimney stay out of either scope.
Covering an open top during brick work
Most brick replacement leaves the top of the chimney closed. When work near the top means lifting the cap or leaving the flue open, rain and debris could get in.
If the chimney is open when we stop for the day, the opening is covered until we return. The cap goes back once the upper work is done. Worn fixings or a damaged cap are pointed out and priced as their own item. Covering the opening is routine for us, not an extra charge.
Using the fireplace during brick work
Brick replacement is outside work, but the mortar around new units is still curing for a while. Heat from a fire warms the masonry and can dry fresh joints faster than they should.
Before the work starts, we say whether to pause fires and when normal use can return. It depends on where the new units are and how close they sit to the flue. If an appliance vents into the chimney, tell us beforehand so its flue stays clear.
What we check before quoting brick work
- Water source notes before replacement
- Sample of the proposed brick match
- Break-out of each damaged unit
- Upfront price for each replacement area
Spalling brick repair questions from Tamiami
Will new bricks stop water getting into the house?
They can close an entry point where broken brick lets water in. Water can also enter through the crown, flashing or joints. We explain what the brick work addresses, and a hose water test comes into it only if the job calls for one.
Does the workmanship warranty cover replaced bricks in Tamiami?
Yes, the agreed brick replacement carries our workmanship warranty. The written record lists which units were replaced and where, so any question later can be checked against the work that was done.
Why does the mortar around new bricks need curing care?
Mortar that dries too fast bonds poorly. We keep the new joints damp and out of strong sun as needed and tell you what to avoid, such as washing or cleaning chemicals, while they harden.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo