Crown repair for chimneys in Lauderhill
We tell you what can stay on your chimney top and what has to come off, with the reasons.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Clues that point to the chimney crown
- Peeling coating from an earlier repair
- Loose cap fixings set into the concrete
- Pieces missing from the crown corners
- Water marks on a ceiling beside the chimney
Jump to
Crown repair that starts with an assessment
Choosing the sealant for the flue joint
Not every tube of caulk belongs on a chimney top. Brick industry guidance recommends a good grade of polysulfide, butyl or silicone rubber sealant at this joint and warns against oil-based sealants. Proper priming and a backing rope are part of the detail.
We tell you which sealant family we plan to use and why. The joint is cleaned and prepared before the new bead goes in. If an earlier repair used a product that has cracked or hardened, we remove it rather than run a new bead over the top.
When the crown is only a leak suspect
A cracked crown is an easy suspect for any chimney leak. It is not always the culprit. Stains inside can also come from the cap, the flashing, the brick face or the roof nearby.
When the source is uncertain, we say so. We explain what the crown inspection confirmed and what it could not. If the job calls for it, we narrow down the entry point with a hose water test. That way the crown repair is chosen because the evidence supports it.
Water standing on the crown after rain
Water that sits on a crown after rain has stopped is a clear sign of poor drainage. It may collect in a low spot, against a flue tile or behind a cap base. Standing water can find its way into any crack nearby.
A coating does not change the shape of the crown. If water stands on your crown, we explain whether a small correction is possible or whether replacement with a sloped crown is the lasting fix. The inspection records where the water collects so the estimate addresses it.
When the crown problem is really a rebuild
Sometimes the crown is only the most visible failure. The top may be leaning, courses may be loose or the masonry may have separated from the house. A new crown alone will not make that sound. Those are structural questions.
We explain when crown repair is enough and when the chimney top needs rebuilding first. A crown formed on loose brick can crack again as the masonry moves. The rebuild, if needed, is described and priced as its own job, and the crown is planned as part of that work.
What the free crown inspection covers
- Crack preparation before any coating
- Formwork for a cast-in-place crown
- Reinforcement planned for a new crown
- Debris removal and haul-away
What people ask about crown sealing
Does the workmanship warranty cover crown repair in Lauderhill?
Yes, the agreed crown work carries our workmanship warranty. Your written record states what was done, which helps if a question comes up later. Trouble from a separate part, such as a failed cap or flashing, is discussed as its own item.
Should I ask about the crown if the fireplace is never used?
Yes. The crown keeps rain out of the masonry whether or not you light fires. Water entering an unused chimney can still damage brick, the flue and nearby ceilings. A free inspection tells you whether the top needs attention.
Do you seal the crown and the chimney brick at the same visit?
They are separate products and decisions. A crown coating treats the top surface. A water repellent for brick is considered only after cracks and joints are repaired, and it should let the masonry breathe. Each appears as its own line.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo