Chimney crown coating and replacement options in Morningside
Chimney crown repair in Morningside with free written estimates and no hidden fees.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Crown problems to point out in Morningside
- A crack running outward from a flue
- Water standing on the crown after rain
- Peeling coating from an earlier repair
- Loose cap fixings set into the concrete
Jump to
The crown repair options we weigh with you
Crown work and a damaged flue liner
The crown surrounds the top of the flue liner, but it does not repair the liner. A cracked tile, a gap between tiles or a liner that has broken at the top are flue problems. They need their own assessment.
When we see liner damage during crown work, we describe it and explain its effect on the crown plan. Sometimes the liner top must be dealt with before the new crown can be sealed to it. That work is priced separately so you can see how the two jobs relate.
Protecting the roof covering during crown work
Concrete, mortar and coatings can mark a roof if they drip or spill. The coating data sheet advises protecting the roof from inadvertent spills during application. We set out protection where material is mixed, carried and applied.
Tell us about roofing that marks easily or is near the end of its life. We would rather know before we step onto it. If a spill does happen, it is cleaned during the work rather than left to set. The written record notes any concern we saw on the roof around the chimney.
Appliances that vent into the chimney during crown work
A chimney may serve more than the fireplace. A furnace or water heater can vent into one of its flues. Crown work must not block a flue that an appliance depends on, even for a short time.
Tell us about every appliance connected to the chimney before the visit. We plan the work so that flue stays open, and we explain whether the appliance should be turned off during any part of the job. Its own servicing is not part of crown repair.
Measuring the chimney top for a precast crown
A precast crown has to fit the chimney it sits on. The outside dimensions, the overhang and every flue opening must match the real top, not an estimate from the ground. Flues that are not centered make measuring more important.
We measure during the inspection or a follow-up visit before ordering a precast unit. If the top is irregular, forming a crown in place may be the better choice. We explain which approach suits your chimney and what either means for scheduling.
Items on a chimney crown estimate in Morningside
- Sealant joint around the flue tiles
- Firmness of the existing concrete
- Removal of loose or hollow sections
- Written record of completed crown work
What people ask about crown sealing
How do you decide between coating and a new crown in Morningside?
We check firmness, slope, the edges and the joint at each flue. A sound crown with surface cracks may take a coating. Broken edges, loose sections or no slope point to removal and a new crown. You see the reasoning before you approve either one.
Do I need to be home while you work on the crown?
Not always. We need access to the roof and a clear area below the chimney. Tell us about gates, pets or parked cars. We walk you through the findings before work starts and again when the job is finished.
Why does a new crown need to overhang the brick?
An overhang with a drip edge throws water clear of the brick face instead of letting it run down the chimney. The code also calls for a drip edge on the top of a masonry chimney. Without one, water can keep soaking the top courses.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo