Chimney crown repair and sealing for homes in Rock Island
Crown repair from a locally owned team that explains each step and backs the work with a warranty.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Crown trouble you can spot without a ladder
- A crack running outward from a flue
- A crown patch that has cracked again
- No overhang past the brick face
- Crown and brick separating along the top course
Jump to
How we approach crown repair in Rock Island
When cracks run through the crown
A crack that runs from the flue to the outer edge may go through the full depth of the crown. Water can then travel down into the chimney. Pieces may also shift or lift as the crack widens.
Through-cracks change the repair. Filling the surface line does not rejoin the concrete underneath, and coatings are meant for sound material. We tap and inspect the sections on either side. When the crown is split into loose pieces, replacement is usually the honest recommendation, and we explain why.
Keeping crown coating off the brick faces
A neat crown repair stops at the crown. Before coating, the top course of brick and the base of each flue tile can be taped to give a clean line. The tape comes off once the application is complete.
That detail matters more than it seems. Coating smeared down the face of the brick changes how the masonry looks and dries. We also protect the roof covering from drips during the work. Ask what protection is planned for your roof when we review the estimate.
A gap between the crown and the brick
Sometimes the crown separates from the top course of brick. A dark line opens along the joint, or the crown rocks slightly when pressed. Water can then run under the crown and into the wall.
The gap may come from failed bedding mortar, movement or loose brick below. We look at which one it is before proposing work. A crown that is sound but loose may be reset. A crown sitting on loose brick needs the masonry addressed first, which is priced as its own item.
Straight cracks across the middle of the crown
A single straight crack across a crown often follows a line of stress from shrinkage or movement. It may be fine and stable, or it may widen over time. The difference shows in its edges and whether the concrete on both sides is still firm.
We look at the crack width, whether the sides sit level with each other and whether water has stained the brick below it. A stable crack in sound concrete may be filled and coated. A crack with one side lower than the other points to movement and a different repair.
Crown work we price line by line
- Crack preparation before any coating
- Precast crown option where the top allows
- Curing time and weather protection
- Upfront price for each crown item
What people ask about crown sealing
Is a mortar wash on top of my chimney the same as a crown?
It sits in the same place, but a thin sloped mortar topping is not built like a formed crown. Brick industry guidance warns that thin, feathered edges are more prone to deterioration. We check whether yours can be coated or should be replaced.
Why does a new crown need to overhang the brick?
An overhang with a drip edge throws water clear of the brick face instead of letting it run down the chimney. The code also calls for a drip edge on the top of a masonry chimney. Without one, water can keep soaking the top courses.
Is there a better time of day for crown coating work?
The product data sets temperature limits and asks for a dry surface with no rain due. On hot days we may work earlier or later so the coating goes on within those limits. We confirm timing when we schedule.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo