Crown sealing and crown rebuilds for chimneys in Three Lakes
Sealing, patching or a new cast crown for homes in Three Lakes, chosen from what the inspection finds.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Crown damage worth mentioning when you call
- A crack running outward from a flue
- Moss or growth holding on the crown
- Loose cap fixings set into the concrete
- Crown and brick separating along the top course
Jump to
How we approach crown repair in Three Lakes
How crown curing time depends on the weather
Crown coatings and new concrete both need time to cure. The coating data sheet gives curing times that vary with temperature. A surface that feels dry to the touch has not always finished curing.
We leave you with instructions based on the material actually used. They cover when the fireplace can be used again and when the cap or other parts can be touched. If another trade plans to work on the roof soon, tell us so the new surface is not disturbed while it cures.
Cap fasteners drilled into the crown
Many rain caps are fastened into the crown or clamped to a flue tile. Holes drilled into a crown are small openings for water if they are not sealed. Loose or rusted fasteners can also crack the concrete around them.
During a crown visit we check how the cap is attached and whether its fixings have damaged the top. If the crown is replaced, the cap comes off and goes back on afterwards when its condition allows. A cap that needs replacing is priced as a separate item, not folded into crown work.
When the crown problem is really a rebuild
Sometimes the crown is only the most visible failure. The top may be leaning, courses may be loose or the masonry may have separated from the house. A new crown alone will not make that sound. Those are structural questions.
We explain when crown repair is enough and when the chimney top needs rebuilding first. A crown formed on loose brick can crack again as the masonry moves. The rebuild, if needed, is described and priced as its own job, and the crown is planned as part of that work.
What to watch after crown repair
After the work, keep an eye on the chimney during the next few heavy rains. Look for new stains inside, drips at the fireplace or streaks under the crown. Those are the places a remaining problem would show.
If you notice anything, write down when it appeared and what the weather was doing. Call us and describe it. Your written record shows what was done, so we can check the repaired top and any other part that could be involved. Fine lines on new concrete are discussed rather than ignored.
Before you approve crown work in Three Lakes
- Precast crown option where the top allows
- Bond-break layer under new concrete
- Cover over an open chimney each day
- Sealant type and backer material at the flue
Questions to ask before crown repair
Do I need to be home while you work on the crown?
Not always. We need access to the roof and a clear area below the chimney. Tell us about gates, pets or parked cars. We walk you through the findings before work starts and again when the job is finished.
What does the free inspection include for a chimney crown?
We look at the crown surface, edges, slope, overhang and the seal at every flue, plus the cap fixings and the brick just below. You hear the findings on site and receive a free written estimate that keeps each item separate.
Is there a better time of day for crown coating work?
The product data sets temperature limits and asks for a dry surface with no rain due. On hot days we may work earlier or later so the coating goes on within those limits. We confirm timing when we schedule.
More Ways to Care for Your Fireplace
- Chimney WaterproofingTreat suitable chimney masonry after checking the surface, repair needs and product requirements.
- Gas Fireplace VentingAssess and repair the gas fireplace vent arrangement using components suited to the identified system.
- Chimney Leak RepairFind the chimney water entry point and plan a repair before restoring the damaged finish.
- Firebox RepairRepair the damaged fireplace chamber using an approach suited to masonry or manufactured components.
- Top-Sealing Damper InstallationFit a top-mounted damper only after checking the fireplace, product restrictions and control route.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo