Chimney damper replacement for homes in Country Club
A damper should open fully, close squarely and move from the room. We work toward all three.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Damper problems worth a free inspection
- Soot stains above the fireplace opening
- Insects getting in through the fireplace
- Control that needs force to move
- No damper visible above the opening
Jump to
Damper service for fireplaces in Country Club
Rotary crank controls
A rotary control uses a crank on the fireplace face or just inside the opening. Turning it drives a small gear or screw that moves the plate. It gives fine control, but it has more moving parts than a simple rod.
When the crank spins without moving the plate, the gear or the rod behind it has usually slipped or stripped. When the crank will not turn at all, rust has often locked the mechanism. We trace the fault from the crank back to the plate and say which piece has failed before any part is ordered.
Damper parts inside a factory-built unit
A factory-built fireplace is a listed assembly. Its damper, its control and the parts around them were tested as part of that listing. The Florida Building Code asks that such fireplaces be installed to their listing and the manufacturer's instructions.
That means replacement damper parts come from the manufacturer's parts list for your model. A generic plate meant for a masonry fireplace is not a substitute. We find the model information, check which listed parts are available, and tell you plainly if the design has been discontinued.
A damper question when you buy a home
A new home can come with a fireplace nobody has used for a while. The damper may work perfectly, or it may be rusted in place. The seller may not know either way, and a quick look at the handle will not settle it.
Ask for any manuals or records that came with the fireplace. Before you plan a fire, try the control gently and see whether the plate moves. If it does not, or you cannot tell, the free inspection covers the damper, and the estimate lists anything it needs.
What happens to the old damper parts
When we replace a plate, control or frame, the old parts are removed from the fireplace. You can see them before they go, if you want to understand what failed and why.
Old parts, rust scale and debris are bagged and hauled away when the job is finished. Nothing is left in the firebox or on the smoke shelf. If a part is reusable and you want to keep it, tell us before the work begins, and we set it aside instead of disposing of it.
Inside a damper replacement quote
- Control handle, rod or crank review
- Pivot cleaning and freeing
- Firebrick removed and reset for access
- Hearth and floor protection during work
Your damper repair questions in Country Club
Will a new throat damper stop all air from escaping?
A throat damper is not airtight. A cast plate closes metal against metal and leaves small paths for air. A good repair closes the plate squarely, without wide gaps or rattle, which limits the loss.
Do you need to remove firebrick to replace a damper frame?
Sometimes. Setting a new frame can mean removing and resetting some masonry around the throat. If that is needed, it appears on the estimate before you approve, together with how the brick will be reset.
Should I close the damper while embers are still glowing?
No. Leave the damper open until the fire is out and the firebox has cooled. Glowing embers still give off smoke and gases, and those need the open flue to leave the house.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo