Chimney damper replacement for homes in Sunny Isles Beach
Factory-built or masonry, your fireplace damper is repaired with parts that suit its design.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Damper symptoms you can check from the room
- Rattling above the fireplace on windy days
- Daylight visible past the closed plate
- Damp debris resting on the smoke shelf
- Cooled air drifting up the flue
Jump to
Damper decisions, one part at a time
What a throat damper seal can achieve
A cast throat damper closes metal against metal. Even a new one leaves small paths for air around the plate. That is normal for the design and not a sign of poor work.
What you should expect after repair is a plate that closes fully and evenly, without wide gaps or rattle. If you want a closer seal than a throat damper gives, tell us. We explain the options and what each would change, rather than promising more from the throat damper than it can deliver.
Setting two damper estimates next to each other
If you compare estimates for damper work, check what each one replaces. One may free and clean the existing plate, another may replace the control, and a third may replace the whole assembly. Those are very different jobs.
Ask each company what failed and why their method fixes it. Ask whether masonry around the throat will be disturbed and how it will be reset. Our estimate answers those points in writing, so you can compare like with like and choose on the facts.
Keeping the written record of damper work
The written record of the work lists the damper parts and what was done with each. It notes the control type, any part numbers and anything we saw that was left outside the job.
That record is useful later. It helps the next person who works on the fireplace, and it answers questions when a home is sold. If the same fault appears again, the record shows what was done and when. Keep it with the fireplace manual, if you have one, and bring it out at maintenance visits.
Dampers in wood-burning fireplaces
This work covers dampers in wood-burning fireplaces, both masonry and factory-built. The damper in these fireplaces closes the flue when there is no fire and opens it fully when there is one.
If your fireplace burns gas, its needs are different and are covered by our gas fireplace services. Tell us which fuel your fireplace uses when you call. That way the visit is planned for the right fireplace, with the right parts on hand for the job. A fireplace that has been converted before is worth mentioning too.
Inside a damper replacement quote
- New damper assembly, where needed
- Frame reset with heat-rated mortar
- Firebrick removed and reset for access
- Open throat covered at each day's close
What people ask about their dampers
Can a rusted damper plate be saved, or must it go?
Often it can be saved. Light rust cleans off, and seized pivots can usually be freed. A plate that has rusted through, split or warped badly is replaced. We show you which case applies during the free inspection.
Why does the damper rattle when the wind picks up?
A loose plate, worn pivots or a slack control rod can let the plate move in air currents. We find which part is loose and tighten, adjust or replace it. Tell us whether it rattles with the plate open or closed.
Can a replacement control be placed where I can reach it?
Often, yes. When a control is replaced, we place it where it can be worked from the room without leaning into the firebox. The code expects the damper to be operable from the room, so that is part of the goal.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo