Chimney reflashing and flashing repairs in Bayside
Counter flashing set back into sound joints, step pieces lapped with the roofing, and sealant only where it belongs.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
When the chimney flashing may be the cause
- Rust streaks on roofing below the chimney
- Nail heads showing through the flashing
- Leaves and grit piled behind the chimney
- Metal bent or lifted after strong wind
Jump to
Reflashing and repairs for chimneys in Bayside
Rain that arrives from the side
In a storm, rain does not only fall straight down. Wind drives it sideways against the chimney, where it can reach the top edge of the counter flashing and the joints above it. A junction that stays dry in calm rain may leak only in wind.
Tell us whether the water in your home in Bayside appears only in wind from a certain quarter. A pattern like that singles out one face of the chimney. We check the upper edge of the metal on that face with care, because a joint that sheds falling rain can still let driven rain through.
Clear a path to the attic hatch
During the free inspection we may ask to look in the attic around the chimney. It helps to know where the hatch is and to clear the space beneath it. Move anything fragile away from the ladder spot.
If the hatch is in a closet, empty enough of it for a ladder to stand. Tell us if the attic has no floor near the chimney or if access is difficult, and we will plan for it. A short look from the hatch can confirm whether water is reaching the framing beside the stack.
When the roofer and the chimney company disagree
It is common for a roofer to say the chimney is leaking and for a chimney company to say the roof is. You are left in the middle with a stain that keeps growing. The way out is evidence, not opinion.
We explain what we saw at the junction, what we saw elsewhere on the roof and what we could not check. If the flashing is sound, we say so plainly. Where the evidence points at roofing away from the chimney, the findings say that too, so you can take them back to the roofer.
Why roof cement is not the joint
Black roof cement is a roofing material. It is meant for setting and patching roofing, and it often ends up spread over chimney flashing as a quick fix. It can hide a failed lap for a while, but it does not make a lapped, sealed junction.
Where we find thick roof cement at the chimney, we explain what it seems to be covering. If the metal underneath is sound, the cement may be cleaned back and the joint sealed properly. If not, the estimate describes the replacement pieces, and the cement comes off with the old metal.
What the flashing estimate covers in Bayside
- Counter flashing and its mortar joint
- Shingle condition next to the stack
- Flashing metal named in writing
- Interior stain noted for follow-up
Chimney flashing answers for Bayside homes
Do you lift and replace the tiles or shingles around the chimney?
We lift and restore the roofing next to the chimney as part of the flashing work. If pieces break or are too worn to reuse, replacements are listed as a separate item. Wider roofing work is a job for a roofer, and we say where our scope stops.
What should I mention when I book a flashing check?
Where the water appears, whether it shows during rain or later, the roof covering and any earlier repairs at the chimney. If you have papers from past roof or chimney work, keep them handy. Rough answers are fine.
Does flashing on a stucco chimney work differently?
The counter flashing has to meet cement plaster rather than brick joints. It may be set into a cut in the stucco or finished against a stop. Cracked stucco near the roof line is checked first, and stucco repair is priced separately.
More Ways to Care for Your Fireplace
- Ventless Gas Fireplace ServiceService the identified vent-free appliance without bypassing its required safety components.
- Fireplace Hearth RepairRepair the hearth surface after considering the supporting assembly and fireplace requirements.
- Chimney Damper Repair and ReplacementRestore a usable damper mechanism after checking the plate, frame and control linkage.
- Chimney Masonry RepairRepair affected chimney brickwork and joints with materials selected for the construction already in place.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo