Flashing repair where the chimney meets the roof in Golden Heights
Clear boundaries between flashing, masonry and roofing work, written down before anyone lifts a tile or shingle.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Flashing problems we look for in Golden Heights
- Counter flashing standing away from the brick
- Rust streaks on roofing below the chimney
- Drips in the attic near the brick
- Leaves and grit piled behind the chimney
Jump to
What goes into a lasting flashing repair
Check your roof warranty before work begins
If your roof is fairly new, it may carry a warranty from the roofer or the manufacturer. Some warranties set conditions for work on the roof by others. It is worth reading yours before anyone lifts roofing at the chimney.
Ask your roofer whether flashing work by another company affects coverage, and whether they would rather handle the roofing part themselves. We are happy to work alongside them. The estimate then shows which parts each company is doing, and the roof warranty questions are settled before the job starts.
Visible flashing and the parts under roofing
An inspection of flashing covers what is accessible. The exposed metal, the reglet, the laps we can reach and the roofing around the chimney can all be judged directly. The underlayment, the deck and the hidden ends of the step pieces cannot, unless roofing is lifted.
Our findings separate the two. Where a conclusion rests on what we saw, we say so. Where it rests on likely conditions under the roofing, we say that too. The estimate then explains how any surprises found under the roofing would be priced and approved before work continues.
A chimney on the outside wall
Some chimneys run up the outside of the house, and the roof meets only the side facing the building. The rest of the stack stands clear of the roof. Flashing is needed only where roof and chimney touch, often along one face and part of two others.
The joint between the chimney and the house wall below the roof also has to be sealed. We look at where the roof flashing ends and where that wall joint begins. If either has opened, the findings say which, because each has its own repair and its own line in the estimate.
Asking for a second look
If a quote for your home in Golden Heights says the whole chimney needs reflashing and you are unsure, a second look is reasonable. We check the junction on our own terms and tell you what we find, whether or not it agrees with the earlier advice.
Bring any earlier estimate or notes to the visit. We explain where our findings match and where they differ. Sometimes a full reflash is the right answer. Sometimes a smaller repair will do. Either way, you get the reasons in writing.
Scope notes for chimney flashing work
- Lap direction on joined pieces
- Access plan for roof height and pitch
- Debris cleaned up and hauled away
- Flashing where a framed chase meets the roof
Flashing questions before you book in Golden Heights
Do you lift and replace the tiles or shingles around the chimney?
We lift and restore the roofing next to the chimney as part of the flashing work. If pieces break or are too worn to reuse, replacements are listed as a separate item. Wider roofing work is a job for a roofer, and we say where our scope stops.
Should I paint over the ceiling stain now?
Wait until the flashing repair is done and the area has dried. A fresh coat of paint makes it harder to tell whether the stain is still growing. If the mark spreads after the repair, tell us promptly so we can look again.
What does the flashing workmanship warranty cover?
It covers the flashing we installed and the way we installed it, as described in the written record. Parts of the roof or chimney outside the agreed scope are not included, which is why the scope is written out face by face.
More Ways to Care for Your Fireplace
- Gas Fireplace VentingAssess and repair the gas fireplace vent arrangement using components suited to the identified system.
- Chimney Damper Repair and ReplacementRestore a usable damper mechanism after checking the plate, frame and control linkage.
- Firebox RepairRepair the damaged fireplace chamber using an approach suited to masonry or manufactured components.
- Chimney Animal RemovalAssess occupied chimney openings and plan appropriate follow-up cleaning or entry protection.
- Chimney Flue RepairAssess repairs to damaged existing flue linings and distinguish them from a new liner installation.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo