Flashing repair at the roof and chimney joint in Miami Springs
Reseal, reset or reflash, chosen from what we find at your chimney rather than from a price list.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
What failing flashing looks like from indoors
- Rust streaks on roofing below the chimney
- Thick black roof cement around the base
- Stain returning after an earlier patch
- Metal bent or lifted after strong wind
Jump to
How our team handles flashing in Miami Springs
Fasteners driven through the metal
Exposed nail heads in flashing are a weak point. A fastener driven through the face of the metal, rather than hidden under the next course or lap, leaves a hole that depends on its seal. When that seal fails, water follows the nail.
We look for face-nailed pieces and for base metal fastened into the brick. The roofing maker's instructions decide how and where base pieces are fastened. Where fastener holes are part of the problem, the estimate explains how the new pieces will be secured instead.
The layer under the roofing counts too
Flashing is one of two lines of defense at the roof line. Under the shingles or tile there is an underlayment, and at a chimney it should turn up the brick behind the base metal. If that layer was cut short or torn, water that gets past the metal meets bare deck.
We can only judge the underlayment where the roofing is lifted. The estimate says whether we expect to see it and what happens if it is damaged. Repairing it close to the chimney is usually part of the flashing work, while wider underlayment problems are a roofing matter.
Why roof cement is not the joint
Black roof cement is a roofing material. It is meant for setting and patching roofing, and it often ends up spread over chimney flashing as a quick fix. It can hide a failed lap for a while, but it does not make a lapped, sealed junction.
Where we find thick roof cement at the chimney, we explain what it seems to be covering. If the metal underneath is sound, the cement may be cleaned back and the joint sealed properly. If not, the estimate describes the replacement pieces, and the cement comes off with the old metal.
How the counter flashing edge is secured
Brick industry details set the turned edge of counter flashing into a mortar joint and fill the joint solidly around it. Other details hold the edge in a cut reglet and close it with a sealant chosen for the job. Both aim to keep the edge from pulling out and to stop water at the top of the metal.
Which method suits your chimney depends on the mortar, the brick and the space available. We explain the method in the estimate. If the old edge failed because of how it was held, the new method should answer that failure directly.
Flashing details listed before you approve
- Flashing metal named in writing
- Mortar above and beside the reglet
- Access plan for roof height and pitch
- Openings covered at the end of each day
Flashing questions before you book in Miami Springs
How do you know the flashing is the source of the water?
We compare where the water appears with what we see at the junction, in the attic and at the top of the chimney. When the evidence is unclear, a hose water test may help if the job calls for it. The findings say what points where.
Will you need to go into the attic?
It helps if the attic is reachable. Stains, damp framing or wet insulation beside the chimney tell us a lot about where water gets in. Please clear a path to the hatch. If there is no access, we work from the roof and the rooms below.
Can one side of the flashing be fixed without the others?
Yes, if the other faces are sound. The new pieces have to lap correctly into the old ones at each corner. If the old corners are too worn to join, we explain why the work should extend around them.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo