Flashing repair at the roof and chimney joint in River Run
Clear boundaries between flashing, masonry and roofing work, written down before anyone lifts a tile or shingle.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Flashing trouble you may notice in River Run
- Gaps along the top edge of the metal
- Dark or soft roof deck by the chimney
- Cracked sealant along the mortar joint
- Loose or missing corner pieces
Jump to
Chimney flashing repair in River Run, explained
Rain that arrives from the side
In a storm, rain does not only fall straight down. Wind drives it sideways against the chimney, where it can reach the top edge of the counter flashing and the joints above it. A junction that stays dry in calm rain may leak only in wind.
Tell us whether the water in your home in River Run appears only in wind from a certain quarter. A pattern like that singles out one face of the chimney. We check the upper edge of the metal on that face with care, because a joint that sheds falling rain can still let driven rain through.
A chimney that also meets a wall
Some chimneys stand against an exterior wall, and the roof meets both the chimney and the wall at the same point. That spot has flashing going in two directions, and the wall side ties into the siding or stucco rather than brick.
We trace how the metal turns from the chimney onto the wall and how the wall covering laps over it. A gap at that inside corner can let water into the wall rather than the chimney. The estimate names the wall-side pieces separately, because the finish above them may need a different trade to restore.
Changing the scope after you approve
Sometimes a household decides to add a face, change the metal or hold part of the work for later after approving the estimate. That is fine. Tell us before the work date if you can, so materials and access can be adjusted.
Any change is written down as a revised item with its own figure, and you approve it before it is done. The same applies if we find something new once the roofing is open. Nothing is added to the job, or to the bill, without your agreement.
Seeing the old metal before it goes
Some people like to see the flashing that came off their chimney. Rusted laps, short corners and nail holes explain the leak better than any description. If you would like to see them, ask before the work starts.
We set the old pieces aside at the end of the job so you can look at them. Afterward they are hauled away with the rest of the debris. The written record of the work also describes what was found when the old metal came out.
What we look at before reflashing in River Run
- Roofing lifted and restored at the chimney
- Shingle condition next to the stack
- Wall joint beside an exterior chimney
- Attic framing beside the chimney
Asked often about chimney flashing
Can flashing be fixed while it is raining?
The roof has to be opened at the chimney, and sealants need dry surfaces, so heavy rain usually moves the date. If rain arrives partway through, we cover the open area before stopping. In an urgent situation, we can talk through temporary steps.
Is there a discount on chimney flashing work?
Yes. When you give the go-ahead inside 72 hours of your free inspection, 10% comes off the flashing work. The window counts from the inspection at your home, and nobody will press you to decide sooner than you are ready.
What does the flashing workmanship warranty cover?
It covers the flashing we installed and the way we installed it, as described in the written record. Parts of the roof or chimney outside the agreed scope are not included, which is why the scope is written out face by face.
More Ways to Care for Your Fireplace
- Spalling Brick Repair and Chimney Brick ReplacementReplace deteriorated chimney bricks while retaining suitable surrounding masonry.
- Chimney Leak RepairFind the chimney water entry point and plan a repair before restoring the damaged finish.
- Ventless Gas Fireplace ServiceService the identified vent-free appliance without bypassing its required safety components.
- Smoke Chamber RepairRepair identified smoke-chamber surfaces with the access and material requirements clearly defined.
- Hurricane and Storm Damage Chimney RepairAssess storm-related chimney concerns and distinguish temporary protection from permanent component repair.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo