Flashing repair where the chimney meets the roof in The Crossings
A roof junction repaired properly once, rather than patched again after the next heavy rain.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
When the chimney flashing may be the cause
- Damp wall next to the chimney breast
- Gaps along the top edge of the metal
- Drips in the attic near the brick
- Stain returning after an earlier patch
Jump to
Reflashing and repairs for chimneys in The Crossings
Step flashing follows the roofing courses
On a shingle roof, the sides of a chimney are usually flashed with separate step pieces. Each piece sits under one course of roofing and over the piece below it. Water running down the slope is handed from one piece to the next and back onto the roof.
The Florida Building Code allows sidewall flashing by the step method or a continuous angle piece. For chimneys on shingle roofs, it points to the shingle maker's instructions. We read the roofing in place before choosing. Tell us if the roof was replaced recently, since new roofing sometimes goes over old step pieces.
How the free inspection of the flashing runs
The visit to a home in The Crossings usually begins indoors, where you show us the stain or the wet area. We then look at the chimney from the ground and, where access is safe, from the roof. If the attic is reachable, we check the framing around the chimney as well.
Once we have seen the junction, we explain what we found, face by face, and what we could not see without opening roofing. You receive a written estimate for the work we recommend. Nothing is started during the inspection itself, so you have time to read it and decide.
Water that shows up on a lower floor
Water that gets past chimney flashing may not appear right beside the chimney. It can run down inside a wall or along framing and show up on a lower ceiling, around a window or near the floor. The mark may be some distance from where the water entered.
Tell us about every place you have seen water, even if it seems unrelated. We trace likely paths from the roof junction downward. If the evidence suggests the water is entering somewhere other than the chimney, we say so rather than fitting the symptom to the flashing.
Testing the junction with a hose
When the job calls for it, a hose water test can show whether the flashing is the path. Water is run over one part of the chimney at a time, starting low on the roof and working upward, while someone watches inside. Each stage runs long enough to give water a chance to appear.
The order matters, because water sprayed high on the stack runs down over everything below it. A test is not needed on every job. We explain beforehand why we think it will help, what it may wet inside and how the area will be protected.
Parts of the flashing job we write down
- Counter flashing and its mortar joint
- Lap direction on joined pieces
- Interior stain noted for follow-up
- Hose water test when the job calls for it
Before you approve flashing work in The Crossings
Will you need to go into the attic?
It helps if the attic is reachable. Stains, damp framing or wet insulation beside the chimney tell us a lot about where water gets in. Please clear a path to the hatch. If there is no access, we work from the roof and the rooms below.
Can flashing be fixed while it is raining?
The roof has to be opened at the chimney, and sealants need dry surfaces, so heavy rain usually moves the date. If rain arrives partway through, we cover the open area before stopping. In an urgent situation, we can talk through temporary steps.
What does the flashing workmanship warranty cover?
It covers the flashing we installed and the way we installed it, as described in the written record. Parts of the roof or chimney outside the agreed scope are not included, which is why the scope is written out face by face.
More Ways to Care for Your Fireplace
- Chimney RebuildRebuild the affected chimney section with the retained structure, roof connection and passage included in the plan.
- Chimney Leak RepairFind the chimney water entry point and plan a repair before restoring the damaged finish.
- Chimney WaterproofingTreat suitable chimney masonry after checking the surface, repair needs and product requirements.
- Chimney TuckpointingRenew deteriorated mortar joints around chimney bricks that can appropriately remain.
- Stone Chimney RepairRepair affected stone chimney surfaces with the supporting construction and visual match considered together.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo