Chimney flashing repair for homes in West Park
Each face of the chimney is checked, and the estimate says which flashing stays, which goes and why.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Flashing problems we look for in West Park
- Drips in the attic near the brick
- Stain returning after an earlier patch
- Wet attic insulation around the stack
- Leak that started after a roof replacement
Jump to
Chimney flashing repair in West Park, explained
Choosing the metal for the new pieces
Flashing metal has to resist corrosion and hold its shape where the chimney meets the roof. Brick industry guidance favors stainless steel and copper for chimney work. It advises against aluminum set into fresh mortar, because the alkalis in mortar attack it. Copper can stain the masonry below it.
We explain which metal we propose and why it suits your chimney and roof. If an earlier repair mixed metals, we point that out, because some metals corrode faster where they touch. The metal named in the estimate is the metal that goes on the roof.
An open roof at the end of the day
Some flashing jobs take more than one working day, especially when tile has to come up or a reglet has to be recut. Roofing left open overnight invites water in. When work stops for the day, any opening at the chimney is covered before we leave.
The estimate says whether the job is expected to run past one day. If weather changes the plan partway through, we tell you what is covered, what is finished and what remains. You should not have to guess the state of your roof between visits.
Watching the junction after the repair
After new flashing goes in, the best test is the next heavy rain. Check the attic and the ceiling near the chimney during and after that rain, if you can do so safely. Dry framing and no new marks are what you want to see.
Existing stains may take a while to fade or may need repainting, so judge by whether the mark grows. If water appears again, tell us promptly. A hose water test may help at that point when the job calls for it, and we explain what the workmanship warranty covers before any further work.
Dust and noise when a reglet is cut
Cutting or cleaning out a reglet makes dust, and some of it drifts. We plan for it by covering what needs covering below the chimney and keeping cars and outdoor furniture clear. Tell us about anything near the chimney that you want protected.
Close nearby windows while that part of the work is going on, and keep pets indoors. The noise is brief compared with the rest of the job. When the cutting is done, dust and debris are cleaned up and hauled away with the old metal.
Line items in a flashing proposal
- Shingle condition next to the stack
- Old roof cement cleaned back or removed
- Wall joint beside an exterior chimney
- Crown and cap noted as separate items
Flashing repair questions, answered plainly
What separates step flashing from counter flashing on a chimney?
Step flashing is the set of base pieces woven into the roofing along the sloped sides. Counter flashing comes down from the brick and covers the top of those pieces. The two overlap rather than join, so each stays with its own surface.
Does a new roof come with new chimney flashing?
Not necessarily. Some roofers replace the base pieces and leave the counter flashing, and some reuse old metal. Ask your roofer what is planned for the chimney. We can assess the counter flashing before the new roofing goes on.
What happens if you find soft roof deck under the flashing?
We stop and show you before doing anything more. Replacing the soft section is a separate item, and we explain whether our team or a roofer should handle it. Nothing extra goes ahead until you approve it.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo