Skip to content
(645) 465-4171

Fireplace inspection and chimney check in Country Club

We tell you plainly when a fireplace should not be used and why, and what would change that.

  • Owned and run locally
  • Available for same-day service
  • Fully licensed and insured
  • Family owned and run

Signs that call for a chimney check

  • A rusted or stuck damper
  • Cracks in the crown or brick
  • A strong storm has passed through
  • Sounds of animals in the flue
Jump to

What our chimney inspection looks at

Inspecting a factory-built fireplace

A factory-built fireplace is listed together with the chimney system it was tested with. The Florida Building Code requires both to be installed as the listing and the manufacturer's instructions say. We look for the listing label, the model and the parts that belong to it.

Panels, the firebox shell, the damper and the visible chimney sections are checked for cracks, rust, gaps and damage. We compare what we see with what the manual shows. Repairs have to use listed parts, so identifying the model matters before any estimate.

Checking clearances to combustible materials

Chimneys and fireplaces must keep a gap between hot surfaces and anything that can burn. The Florida Building Code's chimney and fireplace sections set those clearances. Wood trim near the opening and framing around the chimney both count, and anything stored close by deserves the same caution.

We look at the clearances we can see, such as trim around the opening and framing visible in an attic. Clearances inside finished walls are usually concealed, and we say so. Where a visible clearance looks short, we explain the concern and the options.

Inspecting the chimney after a new roof

A roof replacement disturbs the joint between chimney and roof. Flashing may have been reused, replaced or left short, and debris or tarps may have ended up on the chimney top. CPSC guidance warns that chimneys should not be blocked by tarps or debris during renovation.

We look at the flashing, the top and the flue for anything left behind. Findings are linked to the roof work where the evidence supports it. That can help if you need to raise a problem with whoever did the roof.

Inspecting after changes near the fireplace

Remodeling near a fireplace can bring combustible materials closer to the opening or the chimney. New trim, shelving or wall finishes may sit inside a clearance the code requires. Dust and debris can also settle in the firebox and on the smoke shelf.

Tell us what changed and when. We look at the new materials around the opening and at the hearth and firebox. If something sits too close, we explain the concern and what would correct it. It is easier to adjust new work early than after it has been finished and painted.

What we check on a fireplace inspection

  • Flue lining along the reachable length
  • Chase cover and chase siding
  • Signs of animals or nesting
  • Flue size compared with the opening

Inspection answers for homes in Country Club

Will you tell me if the fireplace is unsafe to use?

Yes, plainly and in writing. When a finding rules out using the fireplace ahead of a repair, you hear it before we leave, along with what would change that.

Will you look at a fireplace that has an insert?

Yes. We look at the surround, the visible connection and the liner top. Some parts cannot be seen without moving the insert, and we tell you which. Moving it would be a separately agreed step.

Is a chimney that serves a gas appliance included?

Yes. We identify the flue and look at its condition and the top as far as access allows. The appliance itself is a separate gas service matter, and we tell you when it needs that visit.

Proudly American

Local service. Careful repairs. A fireplace worth coming home to.

Call Now (645) 465-4171

Book Your Free Inspection in Miami

(645) 465-4171

Send your details for a free Miami chimney or fireplace inspection. We will call to confirm the appointment.

Chimney & Fireplace Brands We Work With