
Chimney safety inspection for fireplaces in Flamingo Park
Get an honest picture of the chimney before the next fire, the next sale or the next repair.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
What prompts a fireplace inspection
- A strong storm has passed through
- Sounds of animals in the flue
- Rust stains running down the chimney
- No record of any earlier inspection
Jump to
What happens during a chimney check
Questions to ask when booking an inspection
Asking a few questions when you book makes the inspection more useful. These help set the scope.
If the answer to any of these is unclear, ask us to explain before the visit. A clear scope at the start saves confusion at the end. It also means the written record answers the questions you actually asked.
- Which parts of the chimney will be looked at
- Whether the roof and attic will be accessed
- What happens if a part cannot be reached
- How the findings and estimate will be given
When a hidden area needs more access
Sometimes the answer to your question lies behind a finished wall, under a hearth or above a bend in the flue. The free inspection cannot open those areas. We tell you what we suspect and why.
If more access is needed, we describe what it would involve, such as removing a panel or pulling an insert, and what it would cost. It becomes its own scope that you approve or decline. Nothing is opened up without your agreement. If the extra access turns up nothing, we say so and the record shows it.
Inspecting a fireplace that is used often
Regular fires wear a chimney steadily. Heat works on the lining and the firebox, deposits build in the flue and the cap screen can clog. Small problems show up sooner when the fireplace is used a lot.
An inspection for a heavily used fireplace pays closest attention to those wear points. We explain what we see and suggest a sensible time for the next look, based on your use and the condition rather than a general rule. The written record then gives the next visit something to compare against.
Who should be home for the inspection
Someone who knows the house and the fireplace should be there at the start and the end. At the start, they can explain the reason for the visit and any history. At the end, they hear the findings and can ask questions.
If that is not possible, tell us how to reach you. We can go through the findings by phone and send the written record and estimate. Nothing beyond the inspection is done without your approval. If a finding needs a quick decision, we call rather than guess what you would want.
Parts checked during your inspection
- Cap, screen and fasteners
- Listing label on a factory-built unit
- Written record of what was inspected
- Hose water test where the job needs it
Before you arrange a chimney inspection
Do you inspect factory-built fireplaces too?
Yes. We look for the listing label and the model, check the panels, firebox, damper and visible chimney sections, and compare them with the manual. Repairs have to use the manufacturer's listed parts.
Can you find where water is getting into the chimney?
Usually. We look at the crown, cap, flashing and masonry with the timing of the water in mind. When looking alone is not enough, a hose water test can narrow it down when the job calls for it.
Do you inspect the attic around the chimney?
When the chimney passes through an attic that can be entered safely, yes. It can show water stains on framing and clearances that cannot be seen from the roof or the room.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting Copperfield Chimney Supply 
Rutland Heatilator Heat & Glo