Chimney inspection in Hillsboro Beach, explained at the hearth
Recommended work you approve no later than 72 hours after your free inspection comes with 10% off.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Changes worth an inspection visit
- A fireplace you have not used yet
- Water stains near the chimney
- A smell from the fireplace after rain
- Cracks in the crown or brick
Jump to
How a chimney inspection in Hillsboro Beach is carried out
Mixed brands of chimney parts
The sections of a factory-built chimney are made to fit parts from the same listed system. A section, cap or support from a different brand may not have been tested with the rest. That can affect clearances and how the joints seal.
When we see parts that do not match, we note where they are and what they are. We explain why it matters and what the manufacturer's instructions expect. Correcting it is a separate repair, priced after we identify which parts are listed for your system.
Inspecting a fireplace that does not draw
Smoke that spills into the room can have several causes. The flue may be small for the opening, partly blocked or cold. The chimney may end too low for its surroundings, or the house may pull air down the flue.
An inspection looks at each of these in turn. We compare the flue with the opening, check the damper and throat, look at the top and ask about fans and closed rooms. The findings explain which cause fits the evidence and which do not.
Inspecting the chimney after a new roof
A roof replacement disturbs the joint between chimney and roof. Flashing may have been reused, replaced or left short, and debris or tarps may have ended up on the chimney top. CPSC guidance warns that chimneys should not be blocked by tarps or debris during renovation.
We look at the flashing, the top and the flue for anything left behind. Findings are linked to the roof work where the evidence supports it. That can help if you need to raise a problem with whoever did the roof.
Concealed construction around the fireplace
Parts of a fireplace are built to be hidden. Fireblocking around the chimney, the framing clearances inside walls and the base of a factory-built unit behind its finish are examples. The code sets how they are built, but they cannot be seen once the room is finished.
An inspection does not open finished surfaces. We say which concealed parts are relevant to your question and what signs of trouble we looked for around them. If those signs are present, we explain what opening up would involve before anything is disturbed.
What an inspection visit includes
- Flue lining along the reachable length
- Crown condition at the chimney top
- Hearth and hearth extension
- Each flue matched to its appliance
Chimney inspection questions asked in Hillsboro Beach
Is the initial chimney inspection really free?
Yes. The initial inspection of the accessible parts, the findings explained on site and a written estimate for any work cost nothing. Further investigation, such as pulling an insert, is a separate choice with its own price.
Do you go up on the roof during an inspection?
When the roof can be reached and walked safely, yes, because the crown, cap and flashing are often where problems start. If it cannot, we look from the ground or a ladder and say what that view could not show.
Do I have to use you for the repairs?
No. The inspection and any repair are separate decisions. The estimate is yours to keep and compare. Should you book it with us inside 72 hours of your free inspection, a 10% discount applies.
More Ways to Care for Your Fireplace
- Gas Fireplace Repair and ServiceGet a model-specific gas fireplace service plan for the fault you are seeing or the maintenance your unit needs.
- Stone Chimney RepairRepair affected stone chimney surfaces with the supporting construction and visual match considered together.
- Chimney Flashing RepairRepair the chimney-to-roof connection with a scope that accounts for the adjoining roofing and masonry.
- Ventless Gas Fireplace ServiceService the identified vent-free appliance without bypassing its required safety components.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo