
Chimney inspection for homes in Miami Beach
We look at the fireplace, flue and chimney top together and tell you what we found in plain words.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
What people notice before an inspection
- A missing or loose chimney cap
- A strong storm has passed through
- A fireplace sealed by a previous owner
- Rust stains running down the chimney
Jump to
Inspecting your chimney in Miami Beach, part by part
Inspecting the flue lining
The lining is the inner surface of the flue that contains heat and smoke. In a masonry chimney it may be clay tile, a poured material or a metal liner. We look for cracks, gaps at joints, missing sections and signs of heat damage.
How much of the lining can be seen depends on access and deposits. We say how far the view reached from each end. If a section could not be seen, the record states it. We also explain whether cleaning ahead of time or another form of access would give a clearer answer.
Inspecting a cleanout door or ash dump
Some masonry chimneys have a cleanout door low on the flue or an ash dump below the firebox. These openings give access for cleaning. A door that no longer closes, or one that is rusted open, lets air, water or animals in.
We open the door if it moves freely and look at what has collected inside. A door that is stuck is not forced. Its condition is noted, and repair or replacement is listed separately if you want it.
Inspecting a damper at the flue top
A damper at the top of the flue closes with a plate that seals against a gasket, controlled by a cable from the fireplace. We check that it opens fully, closes firmly and that the gasket is intact.
A stretched cable, a torn gasket or a weak spring stops it working as it should. We note each fault and whether it affects use. Repairs are priced separately, and we follow the damper's own instructions when describing them. We also check that the damper suits the fuel and the flue it serves.
Inspecting fireplaces on two floors of one chimney
Where a chimney serves fireplaces on two floors, each usually has its own flue. The Florida Building Code calls for masonry between flues that sit side by side. A fault in that wall can let smoke from one enter the other.
We match each fireplace to its flue and look at both, including the top where they end. If smoke or odor from one fireplace has appeared in the other room, tell us, because it points to a specific problem. The findings describe each flue separately, so it is clear which needs work.
The parts a chimney check reaches
- Cap, screen and fasteners
- Lintel above the fireplace opening
- Written record of what was inspected
- Free written estimate for any work
Asking about an inspection in Miami Beach
Can you find where water is getting into the chimney?
Usually. We look at the crown, cap, flashing and masonry with the timing of the water in mind. When looking alone is not enough, a hose water test can narrow it down when the job calls for it.
Is a quick look from the ground enough?
It can spot a missing cap, a leaning stack or loose brick. It cannot show cracks in the crown, gaps in the flashing or the condition of the lining. We tell you what a ground view could not confirm.
Does the inspection include looking at the flue lining?
Yes, along the length that can be seen from each end. We note cracks, open joints, missing sections and heat damage, and we say how far the view reached.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting Copperfield Chimney Supply 
Rutland Heatilator Heat & Glo