Skip to content
(645) 465-4171

Chimney inspection for homes in Middle River Terrace

From the roof down to the hearth, we inspect what can be reached and name what cannot.

  • Owned and run locally
  • Available for same-day service
  • Fully licensed and insured
  • Family owned and run

Signs that call for a chimney check

  • A fireplace sealed by a previous owner
  • Flaking brick faces on the chimney
  • Scorch marks near the fireplace opening
  • Rust stains running down the chimney
Jump to

What our chimney inspection looks at

Mixed brands of chimney parts

The sections of a factory-built chimney are made to fit parts from the same listed system. A section, cap or support from a different brand may not have been tested with the rest. That can affect clearances and how the joints seal.

When we see parts that do not match, we note where they are and what they are. We explain why it matters and what the manufacturer's instructions expect. Correcting it is a separate repair, priced after we identify which parts are listed for your system.

If a carbon monoxide alarm goes off

A carbon monoxide alarm that sounds is an emergency, not a reason to book an inspection. Do not look for the source. Get everyone out of the house and call 911 from outside. CPSC guidance says to stay out until responders say it is safe to return.

Once the emergency has been handled, the chimney and any connected appliances can be looked at. Keep any notes from the responders. The inspection then focuses on what caused the alarm and what must be fixed before the fireplace is used again.

Flaking brick faces on the chimney

Brick that flakes, pops or loses its face is usually reacting to water trapped inside it. The damage can spread once the hard outer face is gone. BIA guidance on brick maintenance says to find the moisture source before repairing the damage it caused.

We look at how much of the chimney is affected and where the water may be coming from. Replacing damaged brick without dealing with the water only resets the clock. The estimate explains both parts, the brick and the source. We also say whether the damage is spreading or has stopped, as far as we can tell.

A chimney safety inspection in Middle River Terrace

A safety inspection in Middle River Terrace focuses on the conditions that affect whether the fireplace can be used. Those include the lining, clearances to combustible material, the damper, deposits in the flue and blockages at the top.

Each finding is marked by whether it affects use now. If something must be fixed before the next fire, we say so and put it in writing. Other items are explained so you can plan them at your own pace. A safety inspection does not replace the rest of the findings, and we list those as well.

From firebox to cap, what gets inspected

  • Visible clearances to combustible material
  • Attic view of the chimney where reachable
  • Cleanout door or ash dump condition
  • Findings explained at the fireplace

Common questions about chimney checks

Can you find where water is getting into the chimney?

Usually. We look at the crown, cap, flashing and masonry with the timing of the water in mind. When looking alone is not enough, a hose water test can narrow it down when the job calls for it.

Will you look at a fireplace that has an insert?

Yes. We look at the surround, the visible connection and the liner top. Some parts cannot be seen without moving the insert, and we tell you which. Moving it would be a separately agreed step.

Does the inspection include looking at the flue lining?

Yes, along the length that can be seen from each end. We note cracks, open joints, missing sections and heat damage, and we say how far the view reached.

Proudly American

Local service. Careful repairs. A fireplace worth coming home to.

Call Now (645) 465-4171

Book Your Free Inspection in Miami

(645) 465-4171

Send your details for a free Miami chimney or fireplace inspection. We will call to confirm the appointment.

Chimney & Fireplace Brands We Work With