Chimney inspection for homes in Silver Bluff
From the roof down to the hearth, we inspect what can be reached and name what cannot.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Signs that call for a chimney check
- A strong storm has passed through
- Sounds of animals in the flue
- Scorch marks near the fireplace opening
- Cracks in the wall beside the fireplace
Jump to
Chimney safety inspection, step by step
Checking clearances to combustible materials
Chimneys and fireplaces must keep a gap between hot surfaces and anything that can burn. The Florida Building Code's chimney and fireplace sections set those clearances. Wood trim near the opening and framing around the chimney both count, and anything stored close by deserves the same caution.
We look at the clearances we can see, such as trim around the opening and framing visible in an attic. Clearances inside finished walls are usually concealed, and we say so. Where a visible clearance looks short, we explain the concern and the options.
Inspecting when smoke comes into the room
Smoke in the room is a sign that the chimney is not carrying it away as it should. Stop using the fireplace until the cause is known. The problem may be a blockage, a damper that does not open fully or a flue that is too small or too cold.
We look at each possible cause and tell you which the evidence supports. Some are simple to put right and some are not. The estimate explains the fix that matches the cause rather than trying several things at once.
Looking at the base of the chimney
A masonry chimney rests on a footing at its base. Cracks near the base, a gap where the chimney meets the ground or settling of the hearth inside can point to movement below. The Florida Building Code's chimney chapter sets how chimney footings are built.
We look at what can be seen from the ground and from inside. The footing itself is usually buried and cannot be confirmed. If the signs suggest movement, we explain the concern and what further investigation would involve.
Inspecting a metal chimney liner
A metal liner in a masonry chimney should be a listed product, and its instructions say how it must be sized, connected and capped. We look at the top plate, the cap and any visible part of the liner for damage, rust or separation.
We also ask what the liner serves, because a liner sized for one appliance may not suit another. If the listing label or paperwork is available, we check the liner against it. Where we cannot see the whole run, the record says so.
Your chimney inspection in Silver Bluff, itemized
- Cap, screen and fasteners
- Flashing at the roof junction
- Findings explained at the fireplace
- Free written estimate for any work
Asking about an inspection in Silver Bluff
What if part of the chimney cannot be seen?
We tell you which part, why it could not be seen and whether it matters for your question. The written record lists it. If more access is needed, we explain what it would involve and what it would cost.
Do I have to use you for the repairs?
No. The inspection and any repair are separate decisions. The estimate is yours to keep and compare. Should you book it with us inside 72 hours of your free inspection, a 10% discount applies.
Should I have the chimney inspected after roof work?
It is a sensible step. Roof work disturbs the flashing and can leave debris or tarps on the chimney top. We look at the top, the flashing and the flue for anything that changed.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo