
Inspecting the chimney and fireplace in Spring Garden
Tell us what worries you about the fireplace and the inspection is planned around that question.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
What people notice before an inspection
- Smoke coming into the room
- A rusted or stuck damper
- White deposits on the chimney brick
- No record of any earlier inspection
Jump to
Inspection decisions for your fireplace
What a view from the ground can show
Some chimney problems are visible from the ground: a leaning stack, a missing cap, loose brick or heavy staining. Others, such as cracks in the crown or gaps in the flashing, usually need a closer view.
A quick look from the ground is not the same as an inspection. When we can reach the top, we do. When we cannot, we tell you what the ground view showed and what it left unknown. That way a short look is not mistaken for a full one.
Inspecting before you light the next fire
An inspection before a planned fire is a sensible step when the fireplace has not been looked at in some time. It confirms the flue is clear, the damper works and nothing has changed at the top.
Book it with enough time before you intend to use the fireplace. If the inspection finds something to repair, you then have time to decide and schedule it without rushing. A repair squeezed in before a planned fire is harder to do well.
What the smoke shelf reveals during inspection
Behind the damper in many masonry fireplaces sits a flat smoke shelf. Whatever falls down the flue tends to land there: soot, bits of tile, mortar, leaves or nest material. It is one of the most useful places to look during an inspection.
We look at what has gathered on the shelf and match it to its likely source above. Tile fragments point to the lining, and leaves point to an open top. The findings link the debris to the part that needs attention, and clearing it is priced as cleaning.
Outside air inlets serving the fireplace
Some fireplaces draw combustion air through an inlet from outside, with its own small damper or grille. The Florida Building Code's chimney and fireplace chapter includes a section on exterior air supply. If an inlet exists, it needs to be clear and working.
We look for the inlet inside the firebox or hearth and outside the house where it can be found. Blocked grilles, missing screens and stuck dampers are noted. If an inlet was covered over during later work, we explain what that may change.
The inspection scope agreed at the start
- Deposits and blockages in the flue
- Chase cover and chase siding
- Chimney height relative to the roof
- Top-mounted damper and cable
Asking about an inspection in Spring Garden
Can you find where water is getting into the chimney?
Usually. We look at the crown, cap, flashing and masonry with the timing of the water in mind. When looking alone is not enough, a hose water test can narrow it down when the job calls for it.
Does the inspection check clearances to wood and trim?
It checks the clearances we can see, such as trim around the opening and framing visible in an attic. Clearances inside finished walls are usually concealed, and the written record says so.
Do you look at the crown during the inspection?
Yes, when the roof can be reached safely. We look for cracks, failed sealant where the crown meets the flue and a top that holds water. Hairline cracks and wide splits call for different repairs, and we explain which applies.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting Copperfield Chimney Supply 
Rutland Heatilator Heat & Glo
