
Repairing chimney water leaks in Beverly Heights
Cap, crown, masonry, roof junction or chase cover, we find out which one is letting the water in.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Clues that a chimney is leaking
- Water dripping onto the damper or firebox
- Damp patch on the wall near the fireplace
- Grit or mortar crumbs on the hearth
- Water on a lower floor below the chimney
Jump to
Finding the leak before fixing it in Beverly Heights
Water coming in at the top of the flue
An uncovered flue lets rain fall straight down the chimney. The water lands on the smoke shelf, the damper or the firebox floor. Rust on the damper and wet debris in the firebox are common signs of rain coming in from the top.
If your chimney has no cap, or the cap is damaged, that is an obvious candidate. During the inspection in Beverly Heights, we check the cap and the flue opening. Where the top is the source, the cap work is written as its own item, so you can see it separately from anything else we find.
How a leak inspection runs
A leak inspection in Beverly Heights starts inside, where you show us the marks and tell us the history. We then look at the chimney from the ground, from the roof where it is safe and from the attic if there is one. The fireplace and the damper are checked as well.
Once we have seen enough, we explain what we found and what remains uncertain. You receive a written estimate. If more investigation is needed, it is offered as a separate step. Nothing is repaired during the inspection without your approval.
Keeping people clear during the work
While we work on the chimney top or the roof junction, tools and debris can come down. Keep children and pets away from the area below the chimney. If it is a patio, a walkway or a pool deck, we mark it off.
Tell us if a door or path near the chimney needs to stay in use. We can plan around it. At the end of the day the area below is cleared, and the final clean-up includes a sweep for small debris.
Soft roof deck found during the repair
When water has been getting in at the roof junction for a long time, the roof deck next to the chimney may have softened. That is not visible until the roofing is lifted. A soft deck is unsafe to stand on and cannot hold new materials firmly.
We say in advance that the deck condition is unknown until the area is open. If we find damage, we stop and explain it before continuing. Replacing that part of the deck is its own item on the estimate. Some of that work suits a roofer better, and we tell you when it does.
Checked during your free leak inspection
- Damper and smoke shelf water marks
- Firebox floor and hearth
- Earlier patches and coatings noted
- Written record of the completed repair
What people ask about a chimney leak
Can you find a chimney leak that only happens in some storms?
Often, with patience. Your log of when it leaks, the wind direction and where the water appears narrows the search. When the job calls for it, wetting one area at a time with a hose helps, though no hose fully copies wind-driven rain.
How soon should a chimney leak be looked at?
Sooner is better. Water keeps working on the masonry, the damper and the wood around the chimney, even when the stain grows slowly. A small leak caught early usually means a smaller repair and less interior damage.
The chimney started leaking after a new roof. What now?
Tell us when the roof work was done and by whom. The roof junction is a likely suspect, because metal may have been reused or disturbed. We explain what we find in terms your roofer can act on.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting Copperfield Chimney Supply 
Rutland Heatilator Heat & Glo
