Leaking chimney repairs that start with the path in Coral Terrace
Findings written so your roofer, your painter or anyone after them can follow what was checked.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Leak warnings to note down in Coral Terrace
- Wet attic insulation around the chimney
- Damper that has started to stick
- Water on a lower floor below the chimney
- Brown streaks on the chimney breast
Jump to
What goes into tracing a chimney leak
The joint where the chimney meets the house
An outside chimney meets the house wall along a vertical joint. That joint should be closed with flashing, sealant or both. When it opens, rain can run behind the siding or stucco and appear inside near the fireplace.
Because the joint is on the wall rather than the roof, it is easy to miss. We check it during every leak inspection on an outside chimney. Resealing it is often a small item, while any damage to the wall covering is a separate matter.
If the water comes back after a repair
A repaired chimney that leaks again does not by itself mean the repair failed. It may mean a second path that was masked by the first, or a path that only opens in certain weather. Either way, the next step is to look again with the new evidence.
Tell us promptly and leave the marks in place. We check the repaired part first. If our work is at fault, the workmanship warranty covers putting it right. If the water is coming from somewhere else, we explain what we found and quote that path separately.
When a coating was tried first
Some leaks are treated first with a coating on the brick. If the water kept coming, the coating probably missed the path. Water-repellent treatments reduce absorption, but they do not close cracks, open joints or gaps at the top and the roof line.
Tell us what was applied and when. We check whether the coating is hiding anything or trapping water. The findings then focus on the path the coating did not reach. Any future treatment is a separate decision, made after the physical repair.
Grit and crumbs on the hearth
Sand, grit or small crumbs of mortar on the hearth can mean water is washing material out of the chimney. It may come from eroding joints, a crumbling crown or deteriorating mortar inside the flue.
Sweep some into a bag rather than throwing it away, and show it to us. What it is made of helps us tell where it came from. We check the top and the inside of the flue where we can reach. Water that washes out mortar needs to be stopped before the masonry weakens further.
Leak checks listed in your estimate
- Firebox floor and hearth
- Nearby roof openings ruled in or out
- Interior restoration left to its trade
- Follow-up after the next heavy rain
What people ask about a chimney leak
Where does water usually get into a leaking chimney?
The usual entry points are the top of the flue, a cracked crown, the roof junction, the masonry faces and, on framed chimneys, the chase cover. Where the water shows inside gives a first clue, and the inspection confirms which part is responsible.
What if the water is not coming from the chimney at all?
Then we tell you, explain what we saw and suggest which trade to call. Plumbing vents, skylights, attic lines and roofing near the chimney can all send water to the same spot. You should not pay for chimney work that would not stop it.
How soon should a chimney leak be looked at?
Sooner is better. Water keeps working on the masonry, the damper and the wood around the chimney, even when the stain grows slowly. A small leak caught early usually means a smaller repair and less interior damage.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo