Chimney liner installation for fireplaces in Fisher Island
A listed liner, installed to its manual, with a written record of the work when the job is done.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Observations that start a relining assessment
- An inspection note about the flue lining
- No lining visible from the chimney top
- Weak draft after an appliance change
- A cracked tile at the top of the flue
Jump to
A closer look at liner installation
The written record after a liner goes in
When the liner is installed, you receive a written record of the work. It names the liner system, the parts installed, the flue it serves and the appliance it was sized for. That information is easy to lose once the chimney is closed up.
Keep the record with the appliance manual and the liner's own instructions. A future sweep, inspector or appliance installer can start from facts instead of guesses. If you replace the appliance or change fuel, the record shows what the liner was intended for.
Chimney height and a relined flue
A liner does not change how tall the chimney is, and height affects draft. Engineering guidance on fireplace chimneys ties draft to the fireplace opening, the flue area and the chimney height together. Changing one without the others can shift the balance.
If draft was weak before relining, tell us. We look at whether the liner size, the opening and the height are working together. The proposal does not promise that a liner alone will cure a draft problem it was not designed to solve. Where height is part of the issue, that becomes a separate conversation.
How the liner leaves the smoke chamber
In a fireplace flue, the code starts the clay lining at the top of the smoke chamber. A liner that serves an appliance may continue down through the chamber to the connection. How the transition is made depends on the system and the setup.
We describe the lower end of the liner in the estimate: where it starts, what it connects to and how the chamber is left. If the chamber itself needs repair, that is a separate item. You see both before approving either one.
Restoring the fireplace surround after relining
Sometimes a surround or trim piece blocks the connection at the bottom of the flue. It may need to come off and go back on. That is part of the job, and it should be planned rather than improvised on the day.
The estimate says whether anything at the fireplace face will be disturbed and how it will be put back. If the material is fragile or hard to replace, tell us before the visit. We describe the risk plainly and agree the approach with you, so there are no surprises at the end.
Checked and priced before relining in Fisher Island
- Broken tile or obstruction removal
- Each flue identified and assigned
- Debris cleaned up and hauled away
- Concealed sections named in the findings
Common questions about a new flue liner
Does the new liner need insulation around it?
Only the liner's listing can answer that. Some systems require insulation on part or all of the run, some come insulated, and some rely on the space around them. We read the requirement from the manual and state it in the estimate.
Can I use my fireplace while I decide about relining?
If an inspection has raised doubts about the lining, hold off until the question is resolved. A damaged lining can let heat and flue gases reach places they should not. We explain what is known so you can decide with the facts.
Can a liner help if my fireplace has weak draft?
It can when the problem is an oversized, damaged or unlined flue. Draft also depends on the opening, the chimney height and other factors. We explain what the inspection finds and do not promise a liner will cure every draft issue.
More Ways to Care for Your Fireplace
- Chimney Leak RepairFind the chimney water entry point and plan a repair before restoring the damaged finish.
- Stone Chimney RepairRepair affected stone chimney surfaces with the supporting construction and visual match considered together.
- Chimney Animal RemovalAssess occupied chimney openings and plan appropriate follow-up cleaning or entry protection.
- Top-Sealing Damper InstallationFit a top-mounted damper only after checking the fireplace, product restrictions and control route.
- Chimney WaterproofingTreat suitable chimney masonry after checking the surface, repair needs and product requirements.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo