Listed chimney liners installed in Shenandoah
Free inspection first, then a written relining estimate with each part and each preparation step on its own line.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
What points toward a new chimney liner
- Smoke spilling at the appliance door
- A metal liner with no label
- A liner cap that no longer fits
- Soot around the appliance connection
Jump to
A closer look at liner installation
Insulation follows the listing, not a habit
Whether a liner needs insulation depends on the listed system and the chimney it goes into. Some systems require an insulation wrap over part or all of the run. Others arrive insulated from the factory. The listing also ties the liner's clearances to how it is installed.
We read the insulation requirement from the manual of the liner we propose. The estimate says whether insulation is included, what type, and why. Leaving it out to lower a price, or adding it where the listing does not call for it, is not a choice we make on your behalf.
A relining plan starts with a free inspection
The free inspection is where the relining question gets answered with evidence. We look at the appliance, the connection, the accessible parts of the flue and the chimney top. From that we can say whether a liner is the right step and what it would involve.
If a liner is not the right step, you hear that too. Sometimes the problem belongs to another part of the chimney. Relining that you approve inside 72 hours of the free inspection is priced at 10% off, and the estimate shows that figure before anything starts.
Roof access for a relining job
Relining means working at the chimney top, which means working on the roof. The roof covering has to be protected where ladders, lines and equipment rest. We plan that access at the assessment rather than on installation day.
If the roof has been damaged near the chimney, tell us before the visit. We note anything we see, but roof repairs belong to a roofing contractor. The estimate describes how we reach the chimney and what we protect along the way. Mention any skylights, rooftop equipment or fragile areas near the chimney.
Keeping an open fireplace after relining
A liner can serve an open masonry fireplace as well as an appliance. The sizing then follows the fireplace opening, and the lower end transitions above the smoke chamber. The finished flue should still carry smoke up rather than back into the room.
If you mainly burn in the open fireplace, say so at the inspection. We explain whether relining suits that use and what the transition involves. The estimate states the rule used to size the liner, so the choice can be checked later. A fireplace you use often deserves that check.
Checked and priced before relining in Shenandoah
- Glazed deposit removal where found
- Wall opening sealed around the tee
- Unused flue closure as a separate item
- Debris cleaned up and hauled away
Liner installation answers in Shenandoah
Can a liner go inside the clay tile that is already there?
That depends on space and condition. If the old tile leaves room for the liner and whatever insulation its listing needs, it can usually stay. Broken sections that block the route, or a passage that is too tight, may require removal before installation.
Does a relined flue still need cleaning?
Yes. A liner gives flue gases a sound passage but does not stop deposits forming. The liner's manual explains how it should be cleaned and inspected, and maintenance visits from our team can include the liner, cap and top plate.
What if the liner will not fit down my flue?
Then the options are preparation, such as removing broken tile, or a different liner form that suits the route. If neither works, we explain what that means for the appliance. You hear this at the assessment, not on installation day.
More Ways to Care for Your Fireplace
- Chimney WaterproofingTreat suitable chimney masonry after checking the surface, repair needs and product requirements.
- Smoke Chamber RepairRepair identified smoke-chamber surfaces with the access and material requirements clearly defined.
- Wood-Burning Fireplace Insert InstallationFit a wood-burning insert after assessing its host fireplace and full connection requirements.
- Chimney Masonry RepairRepair affected chimney brickwork and joints with materials selected for the construction already in place.
- Prefab and Zero-Clearance Fireplace RepairIdentify and repair manufactured fireplace components using the appropriate model information.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo