A chimney mason for masonry repairs in Cutler Bay
We look at the brick, the joints and the water path together, then repair them in the right order.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Cracks and gaps in chimney masonry
- Stepped cracks along the mortar joints
- Top courses shifted out of line
- Plants growing from chimney joints
- Brick dust on the patio below
Jump to
Chimney masonry work, step by step
Chimney masonry inside the attic
Where the chimney passes through the attic, its masonry is out of sight but not out of the weather. Water that gets past the flashing or through the face often shows first as staining, damp mortar or loose sand on the attic side.
If the attic is safely accessible, we include a look there in the visit. That view helps tie outside damage to its effect inside. Masonry repairs in the attic are priced separately, and we note any framing that sits too close to the chimney while we are there.
Masonry where flashing enters the joint
At the roof line, the upper layer of flashing is usually let into a mortar joint in the chimney. That joint carries metal and sealant as well as mortar, and it often fails before the joints around it.
When we repair masonry near the roof, we check that joint and the flashing edge within it. If the flashing needs resetting as part of the masonry work, the estimate says so and names who handles the roof covering. A new joint around an old, loose flashing edge would not keep water out.
Cutting out a damaged brick
Replacing a single brick starts with breaking it out and cutting away the mortar around it. The brick industry's guidance stresses doing this without damaging the adjacent units, then cleaning the opening of dust and debris.
The care taken at this step decides whether the repair stays small. Rough removal can crack the bricks next door and turn one unit into several. We work from the damaged brick outward and stop at sound material. Any extra damage found during removal is shown to you before the scope changes.
Planning masonry around the weather
Rain, heat and wind all affect how fresh mortar sets. A heavy shower soon after repointing can wash out joints, and strong sun can dry them before they bond.
We plan masonry steps for suitable weather and adjust when the forecast changes. Moving a day does not change the scope or the price. We cover open work at the end of each day, and we tell you which steps depend on dry conditions so a pause in the work makes sense.
Chimney masonry work, itemized
- Loose top courses taken down and relaid
- Crack pattern mapped before repair
- Shoulder surfaces reshaped to shed water
- Chimney breast cracks traced indoors
Chimney brickwork questions
Will the new mortar match the color of the old joints?
We aim for a close match and compare samples wet and dry before the work. Weathered mortar can be hard to match exactly, so we show you the likely result before you approve.
Should the brick be sealed after the masonry repair?
Only if it helps your chimney. A vapor-permeable water repellent can be applied once repairs are complete and dry. It is a separate option on the estimate, not a replacement for the repair itself.
Can masonry repairs go ahead in wet weather?
Fresh mortar needs protection from heavy rain while it sets. We plan the work around the weather, cover open work at the end of each day and move a step when conditions call for it.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo