Restoring chimney brickwork in Naranja
A workmanship warranty on the masonry repairs we complete, and a written record of what was done.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Signs the chimney brickwork needs attention
- Gaps where old mortar has washed out
- Top courses shifted out of line
- A gap opening at the house wall
- Stains on the attic side of the chimney
Jump to
Brick, mortar and the cause behind the crack
Fine cracks in the mortar joints
Hairline cracks in mortar are common, and many are not urgent. They can still let water into the wall a little at a time, and water is what damages masonry over the long run.
Where the cracks are few and the mortar is otherwise sound, surface grouting worked into the fine cracks may be enough. Where the mortar has also softened, repointing is the better repair. We explain which applies to your chimney and whether it can reasonably wait. That way a small crack is neither ignored nor oversold.
Decorative bands near the top
Some chimneys have projecting courses near the top, stepped out as a decorative band. The upper face of each projecting brick catches rain and debris, and the joints there wear faster than flat faces.
We look closely at these bands, since loose units in them can fall. Repairs aim to keep the band's shape while making its top surfaces shed water. Where the band cannot be kept safely, we explain the options and how each would change the look before any decision is made.
Framing too close to chimney masonry
The Florida Building Code keeps combustible materials a set distance from a masonry chimney and requires fireblocking where it passes floors and ceilings. Renovation work sometimes brings framing, trim or insulation right up against the masonry.
We look for that during attic and interior checks. Correcting a clearance problem may involve another trade, and we explain what it means for using the fireplace. The finding is listed separately from the masonry repair, so it does not get lost in a long estimate.
Maintenance visits for chimney masonry
Between repairs, a maintenance visit gives the brickwork a planned once-over. For masonry, that means the top courses, the joints on each face, the shoulders and any area repaired before.
Small changes found early are simpler to fix, and a joint that has started to open is cheaper to repoint than a section that has loosened. You decide how often a visit suits your chimney. Each visit ends with the findings explained, and any work is priced separately. There is nothing to sign up for.
Brick and mortar lines on your estimate
- Attic-side masonry checked where accessible
- Chimney breast cracks traced indoors
- Access equipment and roof protection
- Base courses and ground contact checked
Brick and mortar repair questions
Do you need to go on the roof for chimney masonry work?
For work above the roof line, usually yes. We plan the route and protection so the roof covering takes as little wear as possible, and we tell you if a roofer needs to lift any covering.
Will masonry work leave a mess around the house?
We protect the areas below the chimney, clean up as we go and haul the debris away at the end. Mortar smears on the brick are cleaned before we leave.
Do you test for water entry before repairing brickwork?
When the job calls for it, a hose water test on one area at a time can confirm where water gets in. Most masonry visits do not need one, and we explain when it would help.
More Ways to Care for Your Fireplace
- Gas Fireplace VentingAssess and repair the gas fireplace vent arrangement using components suited to the identified system.
- Fireplace Hearth RepairRepair the hearth surface after considering the supporting assembly and fireplace requirements.
- Spalling Brick Repair and Chimney Brick ReplacementReplace deteriorated chimney bricks while retaining suitable surrounding masonry.
- Chimney Sweep and Chimney CleaningArrange careful chimney cleaning in Miami with a defined scope, protected work area and useful findings.
- Smoke Chamber RepairRepair identified smoke-chamber surfaces with the access and material requirements clearly defined.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo