Brick and mortar repairs on chimneys in Surfside
Cracks, open joints and broken brick faces are traced to their cause before any mortar goes in.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
What failing chimney brickwork looks like
- Mortar that crumbles when touched
- A crack running through several bricks
- Hard gray patches over the old mortar
- A gap opening at the house wall
Jump to
Chimney masonry repair at homes in Surfside
Chimney masonry inside the attic
Where the chimney passes through the attic, its masonry is out of sight but not out of the weather. Water that gets past the flashing or through the face often shows first as staining, damp mortar or loose sand on the attic side.
If the attic is safely accessible, we include a look there in the visit. That view helps tie outside damage to its effect inside. Masonry repairs in the attic are priced separately, and we note any framing that sits too close to the chimney while we are there.
Caulk spread over cracked joints
Sealant is sometimes smeared over cracked mortar in the hope of stopping a leak. It may hold for a while, but it does not bond to masonry the way mortar does. Once it starts to peel, it traps water behind it.
Before repointing, that sealant usually has to come out so sound mortar can be placed. We point out where it sits on the visit and include its removal in the scope. That step is easy to overlook in a quote, and it matters for how long the new joints last.
Brick facing on a framed chase
Not every brick chimney is solid masonry. Some are a framed chase around a factory-built chimney, faced with a single layer of brick. That facing needs flashing and weep openings at its base so water that gets behind it can drain out.
If the weeps are blocked or missing, water stays in the wall and can reach the framing. We check for those drainage details as well as the brick and mortar. Repairs to the facing are priced separately from any work on the framing or the listed chimney inside.
A masonry chimney carries only itself
A masonry chimney is heavy and stands on its own footing. The code does not allow it to carry other loads, such as mounted equipment, unless it was designed to. Extra weight, or a pull from a mounted item in the wind, adds stress at the joints.
Tell us about anything that has been fixed to the chimney over the years. We look for cracks around mounting points and at the joints below them. Removing a load that should not be there can be the first step in a lasting masonry repair.
Masonry scope after the free inspection
- Plant growth removed and joints repaired
- Cover over open masonry each evening
- Painted brick condition assessed
- Water repellent listed as a separate option
Chimney brickwork questions
When can I use the fireplace after chimney masonry repair?
Fresh mortar needs time to cure before it takes heat. We tell you the waiting period for the materials used and note it in the written record of the work.
Can masonry repairs go ahead in wet weather?
Fresh mortar needs protection from heavy rain while it sets. We plan the work around the weather, cover open work at the end of each day and move a step when conditions call for it.
Can you remove plants growing out of the chimney joints?
Yes. We remove the growth carefully so it does not pull brick faces away, then repair the joints the roots opened. That work is listed on the estimate with the rest of the masonry.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo