Chimney masonry repair for your home in Watergate
We repair chimney brick and mortar with materials chosen to suit the masonry already in place.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Changes in chimney brick and mortar
- Mortar that crumbles when touched
- Brick chips or sand on the roof
- Paint peeling off chimney brick
- Rust marks around old brackets
Jump to
How we repair chimney brickwork
Masonry where flashing enters the joint
At the roof line, the upper layer of flashing is usually let into a mortar joint in the chimney. That joint carries metal and sealant as well as mortar, and it often fails before the joints around it.
When we repair masonry near the roof, we check that joint and the flashing edge within it. If the flashing needs resetting as part of the masonry work, the estimate says so and names who handles the roof covering. A new joint around an old, loose flashing edge would not keep water out.
Framing too close to chimney masonry
The Florida Building Code keeps combustible materials a set distance from a masonry chimney and requires fireblocking where it passes floors and ceilings. Renovation work sometimes brings framing, trim or insulation right up against the masonry.
We look for that during attic and interior checks. Correcting a clearance problem may involve another trade, and we explain what it means for using the fireplace. The finding is listed separately from the masonry repair, so it does not get lost in a long estimate.
When individual bricks are the problem
Where the joints are mostly sound but certain bricks have broken or crumbled, the job is unit replacement. Chimney brick replacement covers cutting out the damaged units and setting new or salvaged ones.
Often a chimney needs both, and mixed masonry repair then brings them into one scope. We explain which units need replacing, how many areas are involved and why they broke, so the new bricks do not meet the same fate. The cause of the damage is listed next to the repair.
Questions to ask about a masonry repair
Ask what caused the damage and how the repair addresses it. Ask how the old mortar will be removed, how the new mortar is chosen and how the color will be matched.
Ask what happens if more damage is found, how the roof and ground will be protected and when the fireplace can be used again. Good answers to those questions tell you more about a masonry estimate than the total at the bottom. We expect those questions and answer them on the visit.
What your chimney mason prices
- Crack pattern mapped before repair
- Removal of failed sealant from joints
- Shoulder surfaces reshaped to shed water
- Cover over open masonry each evening
Chimney masonry questions asked in Watergate
Can painted chimney brick be repaired?
Yes, though paint can hide damage and trap moisture. We look at where the paint is failing and what lies beneath. Whether to remove or renew the paint is a separate decision from the masonry repair.
Will masonry work leave a mess around the house?
We protect the areas below the chimney, clean up as we go and haul the debris away at the end. Mortar smears on the brick are cleaned before we leave.
Can you remove plants growing out of the chimney joints?
Yes. We remove the growth carefully so it does not pull brick faces away, then repair the joints the roots opened. That work is listed on the estimate with the rest of the masonry.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo