Chimney rebuild work from removal to crown in Country Walk

If removal shows damage lower down, we stop and show you before the boundary moves.

Owned and run locally
Available for same-day service
Fully licensed and insured
Family owned and run

Call Now (645) 465-4171 Book Online

Clues that the stack needs reconstruction

A gap widening between chimney and wall
Mortar washed out deep in the joints
Stepped cracks down the stack
A bulge in the chimney face

Jump to

Chimney rebuild work at homes in Country Walk

What lies under a full-height rebuild

A masonry chimney stands on its own footing, and the Florida Building Code sets out how that footing is built. For a partial rebuild above the roof, the footing is rarely part of the question.

For a full rebuild, or where the whole stack has moved, the footing matters. It sits below ground and cannot be seen on a normal visit. We explain what the visible signs suggest about it and whether an engineer should assess it before the rebuild is planned. Building new masonry on a base that is still moving would not last.

Metal ties between the new stack and the house

Where a chimney runs alongside the house, it is often tied to the structure. The brick industry's chimney guidance describes corrosion-resistant metal ties between a single-width chimney and the building behind it.

When the rebuild reaches levels where ties belong, we check the existing ties and add or replace them as the courses rise. Rusted or missing ties can explain why a chimney pulled away in the first place. The estimate lists the tie work and the metal used, so it is not left out of sight.

A sample panel before the rebuild

Before the full rebuild, a small sample of brick and mortar laid together helps you judge the result. You see the color, the joint width and the finish once the mortar has dried.

Mortar looks darker when wet, so we let the sample dry before you decide. Once approved, the sample becomes the standard the rebuild is checked against. It avoids discovering a mismatch after several courses are already laid. If the first sample is not right, a second one with a different sand or brick costs little compared with relaying finished work.

Smoke problems and what a rebuild can change

If the fireplace smoked into the room before the rebuild, the rebuild may help, or it may not. A top below the code's height rule or a flue narrowed by damage can be corrected as part of the rebuild.

Other causes, such as a room that is too airtight or a fireplace opening too large for the flue, lie outside the rebuild. We explain what we think caused the problem and what the rebuild can realistically change before you approve it.

Rebuild work, line by line

Clay flue tiles set as courses rise
Tooled joints that shed water
Mortar smears cleaned from finished brick
Flue size kept to suit the fireplace

Rebuilding questions from homes in Country Walk

Is a partial rebuild enough for my chimney?

Often, yes. Damage is usually worst above the roof, where the weather hits hardest. If the masonry below is sound, rebuilding only the damaged top section is the normal approach, and we explain why.

Do I need an engineer before the chimney is rebuilt?

Only when the damage suggests a structural cause, such as a stack pulling away from the house, stepped cracking or signs the base has moved. We explain when that assessment should come first.

Do you need to go into the attic for a rebuild?

Sometimes. If removal goes below the roof line, the attic side shows the masonry, the framing clearances and the fireblocking. We tell you in advance if attic access is part of the plan.

Proudly American

Local service. Careful repairs. A fireplace worth coming home to.

Call Now (645) 465-4171

Book Your Free Inspection in Miami

(645) 465-4171

Chimney & Fireplace Brands We Work With

DuraVent
Olympia Chimney and Venting
Copperfield Chimney Supply
Rutland
Heatilator
Heat & Glo