Chimney rebuilds and flue decisions in Fisher Island
Same-day visits are available when the schedule allows, to make loose masonry safe ahead of a rebuild.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Damage that points toward a rebuild
- A stack that has tipped out of plumb
- Top courses shifted out of line
- Soft mortar you can scrape out by hand
- A top section that sways in the wind
Jump to
What goes into a partial chimney rebuild
Choosing how the new flue is lined
Every masonry chimney must be lined, and the Florida Building Code ties the lining material to the appliance it serves. A rebuild is the natural time to decide how the new section is lined.
The usual choices are clay flue tiles set as the brick goes up or a listed liner fitted inside the new masonry. The right choice depends on what burns in the fireplace, what else vents into the chimney and the state of the lining below. We explain the options and price the lining as its own line.
What the code asks of the new crown
Florida's building code uses the word cap for what the trade calls the crown. That top may be concrete, metal or stone. It must slope to shed water, and it needs a drip edge plus a bond break around the flue lining.
A rebuild ends with a new crown built to that description. We explain the material and shape on the estimate and why each feature is there. A flat mortar wash spread over the top bricks does not meet that description, and we do not build one.
Fireblocking at floors and ceilings
At each floor and ceiling a chimney passes, the code requires the gap between chimney and framing to be closed with noncombustible material fastened in place. That fireblocking keeps fire and hot gases from traveling through the gap.
When a rebuild goes below the roof line, we check the fireblocking at each level we reach. Missing or combustible material is replaced as part of the work or noted for the right trade. The estimate lists the levels where fireblocking is checked or installed.
Metals for a rebuilt top near the coast
A rebuilt top near the sea faces air that carries salt. That marine exposure corrodes galvanized steel faster than inland air does. The thin metal parts of a chimney top, such as caps, flashing and screws, tend to show it first.
For a coastal or near-coast rebuild, we pick the cap, flashing and fastener metals for that exposure. When stainless steel is the choice, its grade matters, since grades differ in how well they resist salt-laden air. The estimate states each metal and grade, so the choice can be checked later.
Reconstruction items after the free inspection
- Rain cap fitted to the flue
- Counterflashing set into new joints
- Clearance to framing at roof and attic
- Structural assessment flagged where needed
Your chimney rebuild questions
Can I use the fireplace while the rebuild is under way?
No. The fireplace stays out of use during the rebuild and while the new masonry cures. We tell you when it can be lit again, based on the materials used and the weather.
What paperwork do I get after the rebuild?
A written record of the work that shows where the rebuild started, what was used for the lining, crown and flashing. Keep it with your house papers.
Do you need to go into the attic for a rebuild?
Sometimes. If removal goes below the roof line, the attic side shows the masonry, the framing clearances and the fireblocking. We tell you in advance if attic access is part of the plan.
More Ways to Care for Your Fireplace
- Prefab and Zero-Clearance Fireplace RepairIdentify and repair manufactured fireplace components using the appropriate model information.
- Spalling Brick Repair and Chimney Brick ReplacementReplace deteriorated chimney bricks while retaining suitable surrounding masonry.
- Fireplace RestorationCoordinate fireplace repairs while preserving suitable existing features and defining the intended use.
- Gas Fireplace Repair and ServiceGet a model-specific gas fireplace service plan for the fault you are seeing or the maintenance your unit needs.
- Chimney Flue RepairAssess repairs to damaged existing flue linings and distinguish them from a new liner installation.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo