
Rebuilding the chimney above the roofline in Hamptons at Boca Raton
A workmanship warranty on the rebuilt section, with every step agreed before it starts.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Signs a partial rebuild may be needed
- A stack that has tipped out of plumb
- A gap widening between chimney and wall
- Bricks crumbling to sand
- Rust stains from failed metal ties
Jump to
Planning a rebuild above the roofline
The usual order of a rebuild
Most rebuilds follow a clear order. We set up access, protect the roof, the ground and the fireplace opening, then take the damaged section down to the agreed line and prepare the base.
New courses go up with the flue lining and the counterflashing built in. The crown is formed with its drip edge and bond break, the cap is fitted, and the work area is cleaned. At each stage, you know what is next and what has been done.
When the flue is the main problem
Where the masonry is sound but the flue lining is cracked or missing, the lining can often be dealt with without a rebuild. Chimney liner installation covers fitting a listed liner inside the existing chimney.
If a rebuild is going ahead anyway, it is a good time to decide on the lining for the whole flue. We explain how the two jobs fit together and price the lining as its own line in either case. A rebuild does not settle the lining question by itself, so the two stay separate lines even when they share a visit.
When the roof junction is the problem
Water at the roof junction can make a chimney look worse than it is. Where the masonry is sound and the flashing has failed, chimney flashing repair can stop the water without a rebuild.
We check the masonry above and below the flashing before deciding. If the brick around the junction has broken up, rebuilding that section may be needed to give the new flashing a sound surface. The estimate explains the choice. Flashing repair on sound brick is a much smaller job, and we price it that way. You see the flashing and the masonry findings side by side.
Smoke problems and what a rebuild can change
If the fireplace smoked into the room before the rebuild, the rebuild may help, or it may not. A top below the code's height rule or a flue narrowed by damage can be corrected as part of the rebuild.
Other causes, such as a room that is too airtight or a fireplace opening too large for the flue, lie outside the rebuild. We explain what we think caused the problem and what the rebuild can realistically change before you approve it.
How a chimney rebuild is itemized in Hamptons at Boca Raton
- New crown with drip edge and bond break
- Top height checked against the code
- Debris removal and haul-away
- Appliance vent disconnection coordinated
Your chimney rebuild questions
How do you decide how far down to take the chimney?
We look for the point where the masonry becomes sound again: firm mortar, tight units and no cracks running below. The estimate names that level and explains the evidence, and we confirm it once removal reaches it.
Can a chimney that has moved away from the house be rebuilt?
Often, but the reason it moved has to be understood first. We look at the base, the attachment and the crack pattern, and we explain what should be assessed before a rebuild is priced.
What should I have ready before the rebuild visit in Hamptons at Boca Raton?
A way into the room with the fireplace, a route to the part of the yard under the chimney and, if possible, attic access. Records of earlier repairs and any roof plans help us set the boundary and the order of work.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting Copperfield Chimney Supply 
Rutland Heatilator Heat & Glo
