Chimney rebuilding for homes in Hillsboro Pines
The rebuilt stack is laid to the code's height and top rules, with the flue lined for your appliance.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
When a rebuild enters the conversation
- Repairs that keep failing
- Broken brick spread over large areas
- Daylight through the masonry in the attic
- A top section that sways in the wind
Jump to
A rebuild contractor that sets the boundary first
Looseness that runs down through the courses
A few loose bricks at the very top are a repair job. When bricks move by hand several courses down, and the mortar behind them crumbles when touched, the whole section has lost its bond.
Relaying individual units in that condition leaves them surrounded by masonry that is just as weak. We check how far down the looseness goes, course by course, where it is safe to do so. That depth sets the likely removal line for a partial rebuild, and the estimate names it.
Choosing how the new flue is lined
Every masonry chimney must be lined, and the Florida Building Code ties the lining material to the appliance it serves. A rebuild is the natural time to decide how the new section is lined.
The usual choices are clay flue tiles set as the brick goes up or a listed liner fitted inside the new masonry. The right choice depends on what burns in the fireplace, what else vents into the chimney and the state of the lining below. We explain the options and price the lining as its own line.
The fireplace during the rebuild
From the moment removal starts until the new masonry and crown have cured, the fireplace must not be used. Heat would dry fresh mortar too fast, and the flue may be open or blocked with protection.
We tell you when it is safe to use the fireplace again, based on the materials and the weather. If the flue needs cleaning or another check before use, we say so. The written record of the work notes the waiting time and any conditions.
A shattered crown over loose courses
When the crown has broken into pieces, water reaches the top courses with every rain. The bricks under a failed crown are often loose, soaked and stained by the time the crown is noticed.
Replacing the crown alone would sit it on masonry that cannot hold it. In that case, the damaged top courses are rebuilt and a new crown is formed over them. We check how deep the damage goes before setting the removal line. The new crown then goes on over masonry that can support it for the long term.
Rebuild work, line by line
- New brick matched to the lower courses
- Appliance vent disconnection coordinated
- Structural assessment flagged where needed
- Curing time before the fireplace is lit
Before you approve a chimney rebuild
Who handles the roof and flashing during a rebuild?
We set new counterflashing into the courses as they go up. The base flashing and roof covering around the chimney are coordinated with your roofer where needed, and the estimate says who does which part.
Can a chimney that has moved away from the house be rebuilt?
Often, but the reason it moved has to be understood first. We look at the base, the attachment and the crack pattern, and we explain what should be assessed before a rebuild is priced.
Do you need to go into the attic for a rebuild?
Sometimes. If removal goes below the roof line, the attic side shows the masonry, the framing clearances and the fireblocking. We tell you in advance if attic access is part of the plan.
More Ways to Care for Your Fireplace
- Firebox RepairRepair the damaged fireplace chamber using an approach suited to masonry or manufactured components.
- Chimney TuckpointingRenew deteriorated mortar joints around chimney bricks that can appropriately remain.
- Chimney Damper Repair and ReplacementRestore a usable damper mechanism after checking the plate, frame and control linkage.
- Top-Sealing Damper InstallationFit a top-mounted damper only after checking the fireplace, product restrictions and control route.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo