Rebuilding the chimney above the roofline in North Miami Beach
Same-day visits are available when the schedule allows, to make loose masonry safe ahead of a rebuild.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Signs a partial rebuild may be needed
- Mortar washed out deep in the joints
- Repairs that keep failing
- A crown broken into loose pieces
- Masonry too loose to hold new flashing
Jump to
Planning a rebuild above the roofline
Why many rebuilds start above the roof
The chimney above the roof has no shelter. Rain, sun and wind reach it on every side, and water that gets past the top soaks its upper courses first. The brick industry notes that chimneys may need repairs sooner than ordinary walls for that reason.
That is why many rebuilds are partial and start near the roof line. The masonry lower down, protected by the roof and the house, often stays sound. We check it before assuming it is, and the estimate says where the evidence puts the start of the rebuild.
Fireblocking at floors and ceilings
At each floor and ceiling a chimney passes, the code requires the gap between chimney and framing to be closed with noncombustible material fastened in place. That fireblocking keeps fire and hot gases from traveling through the gap.
When a rebuild goes below the roof line, we check the fireblocking at each level we reach. Missing or combustible material is replaced as part of the work or noted for the right trade. The estimate lists the levels where fireblocking is checked or installed.
Keeping debris out of the flue
When the top of a chimney comes off, mortar and brick fragments can fall into the flue and land on the damper or in the firebox. That debris can block the flue or damage the lining below.
We cover the flue opening during removal and clear anything that does fall in. The fireplace opening is sealed from the room side, so dust and debris stay out of the house. Before the rebuild is finished, the flue is checked to make sure it is clear.
Your approval before any removal
Nothing is taken down until you approve the rebuild scope. Once masonry is removed it cannot be put back, so this is the most important approval point in the project.
Take the time you need. Compare quotes, ask questions and, where the damage suggests it, get a structural opinion first. When you approve, the agreed scope becomes the reference for the job. Any change after that comes back to you as a separate item, priced and explained. Approving part of the work, such as the make-safe step alone, is also an option.
Line items in a chimney reconstruction
- Clay flue tiles set as courses rise
- Lining decision for the connected appliance
- Debris removal and haul-away
- Appliance vent disconnection coordinated
Partial and full rebuild questions
Can you reuse the original bricks?
Where they are sound, yes. We clean the old mortar off and check each unit for cracks and broken faces. Damaged bricks are replaced with new or salvaged units chosen to match the courses that stay.
What happens if it rains during the rebuild?
Open work stays covered, and fresh mortar is protected from heavy rain. Steps that need dry weather move to a suitable day, and the scope and price stay the same.
When can the fireplace be used after the rebuild?
Once the new mortar and crown have cured. The waiting time depends on the materials and the manufacturer's instructions, and we give you the timing in the written record of the work.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo