Chimney rebuilds and flue decisions in Pinecrest
Chimney rebuilding in Pinecrest, with any open top sheltered under a cover overnight.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Damage that points toward a rebuild
- A gap widening between chimney and wall
- Mortar washed out deep in the joints
- Flue tiles showing through open joints
- Masonry too loose to hold new flashing
Jump to
How a chimney rebuild comes together
When patches keep coming back
Some chimneys carry layer on layer of earlier repairs: patches over cracks, new mortar over old, sealant over both. When each repair fails soon after the last, the masonry behind it is often too far gone to hold new material.
We look under the earlier repairs where we can and explain what they have been covering. At that stage, another round of patching may cost less today and more over time. Rebuilding the damaged section replaces the tired masonry with new work that has a sound base.
Metal ties between the new stack and the house
Where a chimney runs alongside the house, it is often tied to the structure. The brick industry's chimney guidance describes corrosion-resistant metal ties between a single-width chimney and the building behind it.
When the rebuild reaches levels where ties belong, we check the existing ties and add or replace them as the courses rise. Rusted or missing ties can explain why a chimney pulled away in the first place. The estimate lists the tie work and the metal used, so it is not left out of sight.
Clearance to framing where the stack passes through
The Florida Building Code keeps combustible framing a set distance from a masonry chimney. Where the chimney passes the roof, the attic or a floor, rafters and joists must stand clear of the masonry.
A rebuild that reaches those levels is a chance to check the clearances and correct them where earlier work crowded the chimney. We explain what we find and whether a carpenter or roofer needs to adjust framing. That step is listed separately, so the masonry scope stays clear.
Metal parts that resist corrosion
A rebuild brings together several metal parts: ties, flashing, the cap and its fasteners. The brick industry's guidance calls for corrosion-resistant metals in flashing and caps, since replacing them later means disturbing the new masonry.
We choose metals for each part and name them on the estimate. Metals that will touch each other are chosen to sit well together, or separated. That keeps a sound rebuild from being let down by a rusting part years later. Where you have a preference, such as copper for appearance, tell us and we explain how it would work with the other metals.
What the rebuild scope can include
- New brick matched to the lower courses
- New crown with drip edge and bond break
- Base flashing coordinated with the roofer
- Flue size kept to suit the fireplace
Questions about chimney rebuilding
Will the rebuilt chimney need to be taller than before?
Only if the old top fell short of the Florida Building Code's height rule for chimneys. We check it against the roof and nearby parts of the house and explain any change before you approve.
What happens if it rains during the rebuild?
Open work stays covered, and fresh mortar is protected from heavy rain. Steps that need dry weather move to a suitable day, and the scope and price stay the same.
Can a chimney that has moved away from the house be rebuilt?
Often, but the reason it moved has to be understood first. We look at the base, the attachment and the crack pattern, and we explain what should be assessed before a rebuild is priced.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo