A chimney rebuild contractor for Port Royale
A free inspection first, then a written estimate that shows where removal stops and why.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
What a chimney due for rebuilding shows
- A stack that has tipped out of plumb
- Repairs that keep failing
- Rust stains from failed metal ties
- A bulge in the chimney face
Jump to
Rebuilding from sound masonry upward
Looseness that runs down through the courses
A few loose bricks at the very top are a repair job. When bricks move by hand several courses down, and the mortar behind them crumbles when touched, the whole section has lost its bond.
Relaying individual units in that condition leaves them surrounded by masonry that is just as weak. We check how far down the looseness goes, course by course, where it is safe to do so. That depth sets the likely removal line for a partial rebuild, and the estimate names it.
Access equipment for a rebuild
Rebuilding means working at height for several days with heavy material. Depending on the chimney's height and the roof, that calls for roof staging or scaffolding set against the house.
Access is listed as its own item on the estimate, since it can be a meaningful part of the cost. We plan where equipment stands and how it is protected, and tell you which doors, paths or parking areas will be affected while it is up. Staging stays in place only as long as the work needs it and comes down before the final cleanup.
Your approval before any removal
Nothing is taken down until you approve the rebuild scope. Once masonry is removed it cannot be put back, so this is the most important approval point in the project.
Take the time you need. Compare quotes, ask questions and, where the damage suggests it, get a structural opinion first. When you approve, the agreed scope becomes the reference for the job. Any change after that comes back to you as a separate item, priced and explained. Approving part of the work, such as the make-safe step alone, is also an option.
When the leak comes first
If water is getting into the house and the entry is not yet clear, chimney leak repair is the place to start. Its job is to find where water gets in before any part is replaced.
A rebuild does stop leaks that come from failed masonry at the top, but it is a large answer to a question that may have a smaller one. We explain what the evidence shows about the leak before suggesting a rebuild for it. If the leak turns out to come from the top masonry, the rebuild discussion can follow.
How a chimney rebuild is itemized in Port Royale
- Clearance to framing at roof and attic
- Fireblocking where the stack passes floors
- Tooled joints that shed water
- Curing time before the fireplace is lit
Your chimney rebuild questions
Who handles the roof and flashing during a rebuild?
We set new counterflashing into the courses as they go up. The base flashing and roof covering around the chimney are coordinated with your roofer where needed, and the estimate says who does which part.
What does the workmanship warranty cover on a rebuild?
It stands behind the rebuild work we agreed and completed: the relaid masonry, the crown and the parts we installed. Retained masonry below the boundary and work by other trades fall outside it.
What happens to a furnace vent in the chimney during a rebuild?
If a furnace or water heater vents into the chimney, it has to be shut down or disconnected while the flue is open. We plan that step with a heating or plumbing contractor and include it in the schedule.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo