Rebuilding the chimney above the roofline in Riverland
Same-day visits are available when the schedule allows, to make loose masonry safe ahead of a rebuild.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Signs a partial rebuild may be needed
- A stack that has tipped out of plumb
- Top courses shifted out of line
- Cracks running through several bricks
- Flue tiles showing through open joints
Jump to
Planning a rebuild above the roofline
Saving sound bricks from the old stack
Original bricks from the dismantled section can often be reused. Each one is cleaned of old mortar and checked for cracks, broken faces and softness. Only sound units go back into the new work.
Reused brick helps the rebuilt section blend with the masonry below. It is more work than laying new brick, since each unit must be cleaned and checked, and the estimate reflects that. Where there are not enough sound units, we mix in new or salvaged brick and explain where they will sit.
Curing the new masonry and crown
New mortar and concrete gain strength as they cure. Hot sun and wind can dry them too fast, and heavy rain can wash out fresh joints or mark a new crown.
We protect fresh work while it cures and follow the product instructions for the crown and mortar. The fireplace stays out of use until the curing period has passed. We tell you when it can be lit and note that in the written record of the work. If the weather during the job slowed curing, the waiting time may be longer, and we explain why.
How a rebuild estimate is laid out
A rebuild estimate should read like a project plan. Each stage has its own line: access and protection, removal to the agreed line, new courses, the flue lining, flashing, crown, cap and cleanup.
Separate lines let you compare quotes and see where the money goes. They also show what is not included, such as roofing work by another trade. Ask about any line that is unclear, and we will explain what it covers and why it is there. A single rebuild figure with no breakdown makes that comparison impossible.
A closer flue check once the rebuild is done
A rebuild changes the chimney system. NFPA 211, the national standard for chimneys, fireplaces and vents, treats a change like that as a reason for a closer look.
Before the fireplace goes back into use, we look down the flue from the new top, not only at the rebuilt section. The aim is to confirm it is clear of debris and the lining joins are sound. We explain what we find, including anything below the rebuild that needs its own decision.
How a chimney rebuild is itemized in Riverland
- Scaffold or roof staging
- Fireplace opening sealed during removal
- Appliance vent disconnection coordinated
- Sample panel for brick and mortar
Partial and full rebuild questions
Who handles the roof and flashing during a rebuild?
We set new counterflashing into the courses as they go up. The base flashing and roof covering around the chimney are coordinated with your roofer where needed, and the estimate says who does which part.
Can a chimney that has moved away from the house be rebuilt?
Often, but the reason it moved has to be understood first. We look at the base, the attachment and the crack pattern, and we explain what should be assessed before a rebuild is priced.
What stops water getting into the new top?
The new crown is sloped with a drip edge, separated from the flue lining by a bond break, and the joints are tooled to shed rain. New counterflashing is set into the courses at the roof line.
More Ways to Care for Your Fireplace
- Gas Fireplace InstallationCreate a complete gas fireplace installation plan for the room, appliance and connected systems.
- Prefab and Zero-Clearance Fireplace RepairIdentify and repair manufactured fireplace components using the appropriate model information.
- Chimney TuckpointingRenew deteriorated mortar joints around chimney bricks that can appropriately remain.
- Hurricane and Storm Damage Chimney RepairAssess storm-related chimney concerns and distinguish temporary protection from permanent component repair.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo