Taking a chimney down and rebuilding it in Wynwood
Debris hauled away, the house protected and a written record of the rebuilt section at the end.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
When patching gives way to rebuilding
- A stack that has tipped out of plumb
- A gap widening between chimney and wall
- Top courses shifted out of line
- Masonry too loose to hold new flashing
Jump to
Planning a rebuild above the roofline
Checking flue tiles before they go in
A clay flue tile hidden inside new masonry cannot easily be inspected or replaced. The brick industry's guidance calls for inspecting flue tiles for cracks and other damage just before installation.
We check each tile as it arrives and again before it is set. A damaged tile is set aside rather than built in, and a replacement is ordered. It is a small step, but it protects the whole rebuild, since a cracked lining can let heat and exhaust reach the masonry and the house.
A spark screen on the rebuilt top
A cap may carry a wire mesh around its sides to catch embers and bar birds and animals from the flue. The Florida Building Code sets requirements for such spark arrestors, including a corrosion-resistant screen, enough open area and access for cleaning.
If your cap has a screen, or you want one, we choose a cap that meets those rules and suits the flue. A screen that clogs can restrict the draft, so we explain how it should be checked. The estimate lists the cap with or without a screen, as you choose.
New brick for the courses that stay
In a partial rebuild, the new brick sits directly above the old, so the match matters. Size is as important as color, since a brick that is taller or longer shows in every joint line.
We look for new brick close to yours and bring samples to compare against the retained courses. Where no close match exists, we explain the options, including reusing sound original bricks on the most visible faces. The estimate names the brick chosen and where it will go.
How a rebuild estimate is laid out
A rebuild estimate should read like a project plan. Each stage has its own line: access and protection, removal to the agreed line, new courses, the flue lining, flashing, crown, cap and cleanup.
Separate lines let you compare quotes and see where the money goes. They also show what is not included, such as roofing work by another trade. Ask about any line that is unclear, and we will explain what it covers and why it is there. A single rebuild figure with no breakdown makes that comparison impossible.
Reconstruction items after the free inspection
- Top height checked against the code
- Corrosion-resistant ties where the chimney needs them
- Scaffold or roof staging
- Roof covering protection
Questions about chimney rebuilding
Will the rebuilt chimney need to be taller than before?
Only if the old top fell short of the Florida Building Code's height rule for chimneys. We check it against the roof and nearby parts of the house and explain any change before you approve.
Can the rebuild be split into stages?
Partly. Loose masonry can be made safe first and the rebuild scheduled later. Once removal starts, though, the section is usually rebuilt in one sequence, so the chimney is not left open.
Do you need to go into the attic for a rebuild?
Sometimes. If removal goes below the roof line, the attic side shows the masonry, the framing clearances and the fireblocking. We tell you in advance if attic access is part of the plan.
More Ways to Care for Your Fireplace
- Chimney Leak RepairFind the chimney water entry point and plan a repair before restoring the damaged finish.
- Chimney Crown RepairRepair the damaged chimney top with an approach matched to the crown and supporting masonry.
- Chimney Flashing RepairRepair the chimney-to-roof connection with a scope that accounts for the adjoining roofing and masonry.
- Fireplace Hearth RepairRepair the hearth surface after considering the supporting assembly and fireplace requirements.
- Stone Chimney RepairRepair affected stone chimney surfaces with the supporting construction and visual match considered together.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo