Skip to content
(645) 465-4171

Restore a damaged chimney in Homestead Base

Same-day visits are available when the schedule allows, and each repair still waits for your approval.

  • Owned and run locally
  • Available for same-day service
  • Fully licensed and insured
  • Family owned and run

Chimney damage around homes in Homestead Base

  • Rust streaks down the chimney face
  • A gap between chimney and house wall
  • Smoke that drifts back into the room
  • Lifted metal where chimney meets roof
Jump to

What chimney restoration involves at your home

Cracks near the footing of a chimney

Masonry chimneys stand on their own concrete or masonry footings. Cracks that start low and climb, or a base that has dropped against the house wall, can point to a problem with the footing below.

That part is buried and cannot be seen during a normal visit. We describe what the visible cracks suggest and whether a structural assessment is needed before repairs above are priced. Patching the stack while the base continues to move would not last. The estimate keeps that assessment as its own step, ahead of any masonry work.

Separating a roof leak from a chimney leak

Water near a chimney may not come from the chimney at all. Damaged roof covering close by, a valley that carries water toward the chimney or a failed vent boot can produce a stain in the same place.

We look at the roof around the chimney as well as the chimney itself. If the evidence points to the roof, we say so and suggest a roofer rather than selling chimney work that would not stop the leak. Where both play a part, each item is listed and priced separately.

A flat metal top that holds water

On a framed chase, the metal cover on top should shed water off its edges. A flat or sagging cover lets water pool, and pooled water rusts the metal and finds its way down through seams and fastener holes.

Rust streaks down the chase and staining inside are common results. We check the shape, the seams and the storm collar around the flue pipe. Chase cover replacement handles a new cover, while damage to the enclosure below is priced as a separate repair.

Tree limbs hanging over the chimney top

Overhanging branches can scrape a cap loose, drop leaves into an open flue and keep the chimney top shaded and damp. In strong wind, a limb can strike the stack itself.

Trimming trees is not part of our work, but we note branches that affect the chimney and suggest a tree service where needed. Damage already caused, such as a bent cap or chipped top courses, is assessed and priced along with any other findings. Leaves in the flue are cleared as part of that work.

Scope lines after a chimney damage inspection

  • Flue lining condition review
  • Gap at the house wall assessed
  • Listed replacement parts for metal chimneys
  • Stucco crack routing and patching

What people ask about chimney damage

What happens during the free inspection for chimney damage?

We look at the accessible parts, from the fireplace opening to the top of the chimney, and connect what you noticed with the part behind it. You hear the findings on site, then receive a written estimate that lists each repair separately.

My chimney is a metal flue inside a framed box. Can you help?

Yes. That is a factory-built chimney, and its repairs must stay within the maker's listing. We look for the model label so the correct parts can be ordered, and we repair the framed enclosure as its own item.

Can you repair a chimney that also vents a furnace or water heater?

Yes, with planning. If the repair would interrupt that vent, the appliance may need a heating or plumbing contractor to disconnect and reconnect it, and we build that step into the schedule.

Proudly American

Local service. Careful repairs. A fireplace worth coming home to.

Call Now (645) 465-4171

Book Your Free Inspection in Miami

(645) 465-4171

Send your details for a free Miami chimney or fireplace inspection. We will call to confirm the appointment.

Chimney & Fireplace Brands We Work With