
Chimney and roof repair at homes in Little Gables
We look at the whole chimney, then repair only the parts that need it, with your approval at each step.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Chimney damage that shows up indoors
- A gap between chimney and house wall
- Lifted metal where chimney meets roof
- A stack that leans away from the roof
- Peeling paint on the chimney breast
Jump to
Repairing chimney damage from the cause outward
The masonry top that sheds rain from the stack
On a masonry chimney, the top is covered by a crown, which the Florida Building Code calls the chimney cap. The code allows concrete, metal or stone. It must slope to shed water, carry a drip edge and have a caulked bond break where the flue liner rises through it. Its job is to keep rain off the masonry below.
Cracks in a crown let water into the top courses of brick, where it can loosen mortar and stain the flue. Some cracks can be sealed, while a crown that has broken up needs rebuilding. Chimney crown repair covers that choice in detail once the inspection shows which case you have.
Every repair line names its material
An estimate that says repair chimney leaves too much unsaid. Each line should name what will be used. That might be a mortar suited to the existing brick, a sheet metal for new flashing or a listed part for a factory-built chimney.
Knowing the material lets you compare quotes fairly and understand how the repair will behave. Ask us why a material was chosen and what the alternatives are. Where appearance matters, we discuss color and texture before you approve anything.
A flat metal top that holds water
On a framed chase, the metal cover on top should shed water off its edges. A flat or sagging cover lets water pool, and pooled water rusts the metal and finds its way down through seams and fastener holes.
Rust streaks down the chase and staining inside are common results. We check the shape, the seams and the storm collar around the flue pipe. Chase cover replacement handles a new cover, while damage to the enclosure below is priced as a separate repair.
Roofing work around the chimney in Miami-Dade County
In Miami-Dade County, roofing work falls under the Florida Building Code's HVHZ provisions, a set of roofing and structural rules the code applies to this county. Those provisions can shape how roof covering and flashing around a chimney are removed and reset.
If a repair touches the roof around your chimney, ask what those provisions require for the flashing and covering on your job. We explain which part we handle and which part a roofer handles. Both are named on the estimate so the junction is closed to the right standard.
Priced items for chimney and roof repair
- Rain cap refit or replacement
- Gap at the house wall assessed
- Temporary weather protection until the repair
- Attic-side look around the chimney
Chimney and roof repair questions
Should I keep using the fireplace until the chimney is repaired?
That depends on what was found. If we advise you to stop, keep the fireplace out of use until the repair is complete. Damage that is only cosmetic may not affect use, and we tell you which case applies.
Can you tell whether water comes from the chimney or the roof?
Often, yes. We look at the flashing, the top of the chimney and the roof covering nearby. Where the source is still unclear, a hose water test on one area at a time can separate them.
What should I have ready for the inspection visit in Little Gables?
Clear access to the fireplace and a path to the side of the house below the chimney. Earlier estimates, invoices and any appliance manuals are useful too, though the visit goes ahead without them.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting Copperfield Chimney Supply 
Rutland Heatilator Heat & Glo

