Restore a damaged chimney in Medley
Same-day visits are available when the schedule allows, and each repair still waits for your approval.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Marks that point to chimney damage
- Cracks across the top of the chimney
- Flakes or grit falling into the firebox
- A gap between chimney and house wall
- Cracks that look wider than before
Jump to
What chimney restoration involves at your home
Masonry stack or factory-built metal chimney
Two chimneys can look alike from the street and still be built in very different ways. A masonry chimney is built on site from brick, block or stone. A factory-built chimney is a listed metal system, often hidden inside a framed chase with siding or stucco on the outside.
The Florida Building Code treats them separately. Masonry chimneys follow its construction rules for support, lining and the top, while a factory-built chimney must stay within its listing and its maker's instructions. That difference decides which parts we can use and which repair methods apply, so we confirm the type before writing any repair line.
Bringing an idle chimney back into use
A chimney that has stood unused can collect debris, nests and water damage without anyone noticing. Before the fireplace is used again, the flue, the top and the roof junction should be checked for what has changed during the quiet period.
Tell us how long the fireplace has been idle and whether anything was done to close it off. We look for blockages, loose masonry and signs of water. The estimate separates what must be fixed before use from work that can reasonably wait until later.
When the fireplace can be used after a repair
Fresh mortar and concrete need time before they take heat or heavy wetting. The right waiting period depends on the materials used and the manufacturer's instructions for them.
We tell you when the fireplace can be lit again and what to avoid in the meantime. If another unresolved condition means the fireplace should stay out of use, we say that too. The written record of the work notes those instructions, so they are there when you need them. Ask again at any point if the timing is unclear.
When the leak source is still unknown
Sometimes the visit shows water getting in but not yet where. The top, the face, the roof junction and the flue each remain possible, and guessing would mean paying for work that may not stop it.
In that case, chimney leak repair is the better starting point, because its job is to isolate the entry before any component is replaced. Once the entry is found, the repair of that part is priced on its own. We explain which of the two routes fits what we saw.
Scope lines after a chimney damage inspection
- Flue lining condition review
- Smoke chamber surface assessment
- Cover over an open chimney each evening
- Attic-side look around the chimney
Asked often about chimney damage
Do I need to know which part is damaged before I call?
No. Describe what you saw, where you saw it and when it started. A stain, a fallen piece of brick or a loose cap is enough for us to plan the visit and bring the right equipment.
What does the workmanship warranty cover after a chimney repair?
It stands behind the repair work we agreed and completed. Parts of the chimney we did not work on fall outside it, which is why the estimate and the written record describe each repaired area clearly.
Will I get anything in writing once the work is finished?
Yes. You receive a written record of the work that names the parts repaired and the materials used. Keep it with the estimate, since it helps anyone who works on the chimney later.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo